Installation of Lens and Bulb

AInstall a light bulb (100 Watts or less)(not included) into Light Socket (Figure 14):

•Rough service, 130 Volt bulbs are recommended..

BInstall Lens into slots in Motor Cover.

•Insert Bottom hinges into slots provided in metal front cover of Power Head.

•Flip Lens up and fasten with molded latches on lens..

Figure 14 Install Lens and Light bulb

Notes

Transmitter Compliance Statement

Important Safety Instructions

WARNING

TO REDUCE THE RISK OF SEVERE INJURY OR DEATH

1READ AND FOLLOW ALL INSTRUCTIONS..

2Never let children operate or play with the Door Controls.. Keep the Remote Control away from children..

3Always keep the moving door in sight and away from people and objects until the door is completely closed..

NO ONE SHOULD CROSS THE PATH OF THE MOVING DOOR..

4NEVER GO UNDER A STOPPED, PARTIALLY OPEN DOOR..

5Test Opener monthly.. The door MUST reverse on contact with a 1-1/2” high object (or a 2” x 4” board laid flat) at the center of the doorway on the floor.. After adjusting either the Force or the Limit of travel, retest the Door Opener.. Failure to adjust the Opener properly may cause severe injury or death..

6When possible use the Emergency Release only when the door is closed.. Use caution when using this Release with the door open.. Weak or broken springs are capable of increasing the rate of door closure and increasing the risk of severe injury or death..

7KEEP GARAGE DOORS PROPERLY BALANCED.. See Owner’s Manual.. An improperly balanced door increases the risk of severe injury or death.. Have a Genie Factory Authorized Dealer make repairs to cables, spring assemblies, and other hardware..

8SAVE THESE INSTRUCTIONS.

For Help, call 1-800-35-GENIE or visit www.geniecompany.com