Harman-Kardon MAS 101, MAS 111, MAS 102 owner manual Rear-Panel Connections Amplifier

Page 7

MAS SYSTEM

Rear-Panel Connections Amplifier







Right and Left Speaker Output Terminals: Use two-conductor speaker wire to connect each set of terminals to the correct speaker. Remember to observe the correct polarity (positive and negative connections).

Input From Controller: Connect the included ribbon cable to this connector and to the corresponding connector on the MAS controller. This cable passes audio signals from the controller to the amplifier, and it transfers DC power from the amplifier to the controller. If this cable is ever damaged, do not use it, and contact Harman Kardon for a replacement.

AC Power Input: After you have made all other connections, plug the AC power cord into this receptacle and into an unswitched wall outlet.

NOTE: MAS 101/111 systems require 23OV, 50/60Hz AC current. MAS 102 systems require 120V, 60HZ AC current

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents
MAS 101/102/111 MAS System Table of ContentsImportant Safety Instructions Safety InstructionsHarman Kardon MAS High-Performance Audio System Introduction and FeaturesFront-Panel Controls Controller and Amplifier Rear-Panel Connections Controller Rear-Panel Connections Amplifier Remote Control Functions Transport Controls Bridge Iiip Insert IPod Model InstallationOperation Using the Remote ControlSetting the Clock Setting the AlarmsSetting the Alarms Source Selection Volume ControlSpeaker Setup Tone Controls Program Station PresetsPlayback Control DAB Tuner MAS 111 Systems OnlyData Discs Bridge Iiip Dock for iPod Programmed PlayAuxiliary Inputs System Memory System ResetRecording System Software VersionTroubleshooting TroubleshootingFM Tuner Section SpecificationsSpecifications System LoudspeakersGeneral CD SectionToslink is a trademark of Toshiba Corporation