Chamberlain 3453135556 manual With Permanent Wiring, Instructions for electrician

Page 18

5CONNECTING TO POWER WITH GROUNDED PLUG:

 

 

WARNING

 

 

To reduce the risk of electrical shock, this

18

 

equipment has a grounded type plug that includes

 

 

a third (grounding) pin. This plug will only fit a

 

 

grounded type outlet. If you do not have a

 

 

 

grounded outlet, contact a qualified electrician to

 

 

install one. DO NOT alter the plug in any way. The

 

 

door operator must be properly grounded in order

 

 

to prevent personal injury and damage to

 

 

the components.

 

 

 

CAUTION

Check local building codes to make sure that you are not required to have your garage door operator permanently wired, with circuit breaker protection.

If permanent wiring is required, have this installed by a qualified electrician.

1.Plug the operator into a properly grounded electrical outlet.

2.Check Safe-T-Beam®alignment (Fig. 6-3).

WITH PERMANENT WIRING:

WARNING

The electrical power to the door operator MUST BE turned off when the motor cover is removed. Electrical power must remain off while making electrical connections.

1.Instructions for electrician.

•Remove power from circuit.

•Remove motor cover (Fig. 6-1).

–Removing hex head screw located in center on bottom of cover.

–Slide cover down and off.

•Remove and throw away existing power cord.

•Remove 7/8" knockout plug (Fig. 6-2).

–Install a suitable entrance bushing.

•Connect permanent wiring to power head.

–White to white/black to black/ground to green

–Use only UL recognized wire nuts.

•Wires inside power head must be at least 6" in length.

CAUTION

The circuit board is light sensitive. Make sure the motor cover has been replaced prior to re-energizing the circuit.

•Replace motor cover, and re-energize the circuit.

2.Check Safe-T-Beam®alignment (Fig. 6-3).

NOTE: The Overhead Door Corporation is not responsible for charges resulting from work performed by an independent electrician.

FOR HELP-1.800.929.3667 OR OVERHEADDOOR.COM

screw

FIG. 6-1 Removing motor cover.

knock-out plug

FIG. 6-2 Knock-out plug.

Safe-T-Beam®Alignment Check

After turning the electrical power on, if the STB’s are not in proper alignment, the red LED (Source) will blink continuously.

To correct the problem — the brackets are flexible and can be adjusted slightly to bring the system into alignment.

When the STB’s are in alignment the red LED will stop blinking and stay on.

FIG. 6-3

NOTE: If a problem exists with the “STB” that is preventing the door from closing, the door can be closed by holding the wall control button in until the door is fully closed. (The remote control will not work.)

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Series OCG Things to consider if you are planning to do-it-yourself Typical Sectional Door Installation Typical 1-PIECE Door InstallationTable of Contents Operator FeaturesSafety Features Tools Recommended Parts Identification Not Shown Full SizeParts List Piece Boom Hardware Exploded ViewPower Head Exploded View Power HeadSafety Information Attach boom strap Fig Operator AssemblyOpen Blue Parts BAG Slip carriage into carriage slot of boomSlip opposite no knot end through knob Attach boom to power headOpen Green Parts BAG Attach emergency release tagAttach limit switches Attach limit switch wiresFinding header bracket mounting location InstallationHeader and Door Mounting Brackets Marking final heightMounting the header bracket Open Orange Parts BAGDoor Bracket Finding door bracket mounting locationMounting the Operator Connecting the arms Open Yellow Parts BAGAttach the arms Wiring Mounting bracketsMounting STB source and sensor Wiring cont’ Open RED Parts BAGCheck the following Wall Control Installation Finding the mounting locationMounting With Permanent Wiring Instructions for electricianAdjusting Open force Limit Switch / Force AdjustmentAdjusting limit switches Adjusting Close forceProgramming Remote Controls Single Button Remote Contact Reverse TestMULTI-BUTTON Remote Remote ControlLight BULB/LENS Installation Lost or Stolen RemoteDoor springs and hardware Maintenance Routine Monthly MaintenanceTroubleshooting Guide Door balanceDoor starts down, then stops and goes Back up No reasonRange Noisy operationWiring Diagram Installation Notes Transmitter Compliance StatementLimited Warranty Call Call

3453135556 specifications

The Chamberlain 3453135556 is a reliable and innovative garage door opener designed to enhance convenience and security for homeowners. This model stands out for its robust performance and user-friendly features, catering to a wide range of customer needs.

One of the most notable features of the Chamberlain 3453135556 is its powerful motor, capable of providing up to 1/2 horsepower. This motor enables smooth and quiet operation, making it suitable for residential use where noise reduction is a priority. The opener can effortlessly lift standard and heavier garage doors, ensuring reliable functionality even for larger installations.

Equipped with advanced technologies, the Chamberlain 3453135556 incorporates MyQ smart technology, allowing users to control and monitor their garage door through a smartphone app. This feature offers real-time notifications, enabling homeowners to check if they left the door open or close it remotely. With MyQ, users can also integrate other smart home devices, enhancing the overall home automation experience.

In terms of security, the Chamberlain 3453135556 boasts a unique Security+2.0 technology that utilizes rolling code encryption. This innovation changes the access code each time the remote control is used, significantly reducing the risk of unauthorized access. Additionally, the model includes an automatic garage door lock feature, ensuring that the door remains securely closed when not in use.

Installation is straightforward, as the Chamberlain 3453135556 comes with a clear set of instructions and necessary hardware. Its compact design allows it to fit seamlessly into most garage configurations, and it is compatible with various types of garage door systems.

Moreover, the opener features a reliable safety mechanism that includes infrared sensors, which reverse the door's motion if any obstruction is detected, preventing accidents and injuries. This attention to safety makes it an ideal choice for families with children and pets.

In summary, the Chamberlain 3453135556 stands out as a leader in garage door openers, combining power, security, and smart technology. With its user-friendly features and reliable performance, it offers an excellent solution for modern homeowners seeking to enhance their garage experience. Whether for convenience, safety, or smart home integration, this model delivers on all fronts, making it a valuable addition to any home.
Top Page Image Contents