Chamberlain 3453135556 manual MULTI-BUTTON Remote, Lost or Stolen Remote, Remote Control

MULTI-BUTTON REMOTE

1. Programming.

NOTE: Each button on a multi-button remote is designed for use with 1 door. You cannot program 2 buttons to operate the same door, nor can you program 1 button to operate 2 doors.

•For each button.

–Program each button separately.

–Follow single button remote procedure (previous page) for each button.

2.Operating.

•Same as single button remote.

LOST OR STOLEN REMOTE

1.Clear memory.

•Press and hold learn code button (on power head) for 10 seconds or until Indicator LED goes out.

•Program remaining or new remote controls as done previously. Your door operator will no longer recognize any signal received from the missing remote control, or any other which has not been reprogrammed.

8REMOTE CONTROL

BATTERY REPLACEMENT AND VISOR CLIP INSTALLATION

1.Battery replacement.

• Use coin, ball-point pen or similar device.

–Gently push straight in on battery cover lock tab as shown (Fig. 9-1).

•Flip open battery cover.

–Remove old battery.

•Make sure new battery is facing proper direction (Match battery polarity with symbols inside battery cover) (fig. 9-2).

–Recommended replacement battery is Eveready A-23, 12 volt.

•Slip new battery into place.

–Snap battery cover shut.

•Operate remote to make sure it is working properly. (No re-programming is needed.)

2.Visor clip.

•Slide visor clip into back of remote control.

–It will snap into place (Fig. 9-3).

9LIGHT BULB/LENS INSTALLATION

1.Light bulb.

• Recommendations.

–Do not use a short neck bulb.

–Light bulb should be no more than 100 Watts.

–Use a heavy duty service bulb for longer life.

• Screw bulb into socket.

2.Lens.

• Slide hinges into slots on motor cover (Fig. 10-1).

• Swing lens up.

–Fit tabs into slots provided on power head.

FIG. 9-1 Open battery cover.

+ polarity marks

FIG. 9-2 Match battery polarity.

FIG. 9-3 Attach visor clip.

FIG. 10-1 Slide hinges into motor cover.

FIG. 10-2 Fasten Lens.

21