SYSTEM CONFIGURATION
8.Press the Delay Button 29 23 on the remote or front panel. The words SR DELAY will appear in the Main Information Display F.
9.Press the Set Button o 21 , and then imme- diately press the ▲/▼ Buttons mq on the remote or the Selector Buttons 5 on the front panel until the desired delay time for the surround channels is shown in the display.
10. Press the Set Button o 21 within three sec- onds after the desired setting is shown.
11.Press the ▲/▼ Buttons mq on the remote once so that CT DELAY appears in the Main Information Display F.
12.Press the the Set Button o 21 .
13.Press the ▲/▼ Buttons mq on the remote or the Selector Buttons 5 on the front panel until the desired delay time for the center channel appears in the display.
14.Press the Set Button o 21 to enter the set- ting into the AVR 125’s memory.
Additional Input Adjustments
In addition to the major adjustments described in the preceding pages, you may also wish to set the type of audio source (analog or digital) to be used with an input at this time. Once a specific audio source type is associated with any of the inputs, it will remain in the memory until it is changed, even when another input is selected. To attach one of the digital inputs to a specific source, follow these steps:
1.Press the Digital Button p 24 .
2.Immediately press the ▲/▼ Buttons mq or Selector Buttons 5 to scroll through the list of available digital inputs or the analog input.
3.When the desired input type is shown in both the Main Information Display F and in the Analog S, Coaxial Digital Input T or Optical Digital Input U Indicators, press the Set Button o
21 to enter the setting into the unit's memory.
When the
You may also “memorize” a specific surround mode so that it will always be used when an input is selected. The AVR 125 always remembers the last surround mode used with any input, but during the setup process you may wish to preset the modes for each source. To do that, follow these steps:
1.Select an input by pressing one of the Input Selectors e 35 ! or the AM/FM Tuner Select g.
2.Press the Surround Mode Selector j7, and immediately press the ▲/▼ Buttons mq or Surround Mode Selector 7 to scroll through the list of available surround modes. Note that the name of each mode will scroll from right to left across the Main Information Display F. To avoid having the system “time out” and exit the select process, be sure to press the ▲/▼ Buttons mq or Surround Mode Selector 7 to select the next mode at any time the mode name is displayed.
3.When the desired mode name appears in the Main Information Display F and in the Surround Mode Indicators 29 , simply pause for a few seconds to allow the unit to “time out.” Your selec- tion will be memorized and will be activated each time the input is selected until another mode is selected.
4.Repeat the process for each of the inputs.
5.When the desired Surround mode has been entered for all inputs, press the Set Button o.
Once the settings outlined on the previous pages have been made, the AVR 125 is ready for operation. While there are some additional settings to be made, these are best done after you have had an opportunity to lis- ten to a variety of sources and different kinds of pro- gram material. These settings are described on pages 21 through 26 of this manual. In addition, any of the settings made in the initial configuration of the unit may be changed at any time. As you add new or dif- ferent sources or speakers, or if you wish to change a setting to better reflect your listening taste, simply fol- low the instructions for changing the settings for that parameter, as shown in this section.
Having completed the setup and configuration process for your AVR 125, you are about to experience the finest in music and home theater listening. Enjoy!
20 SYSTEM CONFIGURATION