Graco 306981AD important safety instructions Skin Injection Hazard, Moving Parts Hazard

Page 3

WARNING

SKIN INJECTION HAZARD

Spray from the gun, hose leaks, or ruptured components can inject fluid into your body and cause extremely serious injury, including the need for amputation. Fluid splashed in the eyes or on the skin can also cause serious injury.

DFluid injected into the skin might look like just a cut, but it is a serious injury. Get immediate surgi- cal treatment.

DDo not point the gun at anyone or at any part of the body.

DDo not put your hand or fingers over the spray tip.

DDo not stop or deflect leaks with your hand, body, glove or rag.

DDo not “blow back” fluid; this is not an air spray system.

DAlways have the tip guard and the trigger guard on the gun when spraying.

DCheck the gun diffuser operation weekly. Refer to the gun manual.

DBe sure the gun trigger safety operates before spraying.

DLock the gun trigger safety when you stop spraying.

DFollow the Pressure Relief Procedure on page 9 whenever you: are instructed to relieve pres- sure; stop spraying; clean, check, or service the equipment; and install or clean the spray tip.

DTighten all fluid connections before operating the equipment.

DCheck the hoses, tubes, and couplings daily. Replace worn, damaged, or loose parts immediately. Permanently coupled hoses cannot be repaired; replace the entire hose.

DUse only Graco approved hoses. Do not remove any spring guard that is used to help protect the hose from rupture caused by kinks or bends near the couplings.

MOVING PARTS HAZARD

Moving parts, such as the air motor piston, can pinch or amputate your fingers.

DKeep clear of all moving parts when starting or operating the pump.

DBefore servicing the equipment, follow the Pressure Relief Procedure on page 9 to prevent the equipment from starting unexpectedly.

306981 3

Image 3
Contents Instructions-Parts List Ratio President PumpsRatio Monark Pumps Symbols Table of ContentsMoving Parts Hazard Skin Injection HazardToxic Fluid Hazard Fire and Explosion HazardInstallation General InformationPrepare the Operator Grounding Air and Fluid Hoses Mounting AccessoriesAir Line Accessories Fluid Line AccessoriesModel 223586 Shown 306981 Flush the Pump Before First Use Pressure Relief ProcedureOperation Packing NutStarting and Adjusting the Pump Shutdown and Care of the Pump FlushingExplosion Hazard on Problem Cause Solution TroubleshootingUnder Disconnecting the Displacement Pump ServiceDisconnecting the Displacement Pump Reconnecting the Displacement PumpDisplacement Pump Service DisassemblyReassembly Throat Packing Detail Parts Model 221075, Series CDescription Qty Part Description Qty Model 243664, Series a Model 223586, Series B02506 Packing Description Qty No. Part NoInput Air Pressures at 15 cycles per minute Technical DataSound Power Levels dBa Category DataRatio Monark Pump Ratio President PumpsPage Mounting Hole Layout DimensionsGraco Standard Warranty Graco InformationToll Free