PROBLEM
!, Neither vacuum motor nor pump motor runs.
2, Vacuum motor runs, but there Is no spray at the nozzle.
POSSIBLE SOLUTIONS *
1, Be sure power switch is in "ON" position,
2.Be sure power cord tsplugged In securely,
3.Check wall electrical outlet (by plugging in a known working electrical appliance),
1, Be sure Short Cord from Power Head to Solution Tank is securely plugged Into receptacle on the Power Head,
2, Check that Solution Tank Isfull,
3, Be sure Pump Switch is in the "HI" or _LO" position,
4, Nozzle Ports may be clogged, See Illustration below to unclog,
3, Spray from the floor nozzle does not come out evenly,
i
4, Motor runs but cleaner does not pick up solution from carpet (no exhaust from top of cleaner),
5. Spray connections leak.
!, Unclog the Nozzle Port, See Illustration below,
1, Recovery Tank is full of dirty water and must be emptied. 2, Check for clogged hose or nozzle, Clogs could resuit from
picking up material such as carpet strings, shoe laces, etc.
I, Disassemble nut at leaking connection, Be sure washer is properly seated, Reassemble and tighten securely,
"If the "Possible Solutions" to "Problems" iisted In the chart do not correct the problem, take your cleaner to a Sears Service Center for professional service, Repairs not listed In this chart require prafessional and specific knowledge
of this model cleaner and could result in safely hazards and personal Injury If not made by o qualified Sears Service
Technlclan.
TO UNCLOG NOZZLE PORT
See Fisu re 18
1.Insert the point of a needle or pin into Spray Port to unclog,
CAUTION: Do not let needle or pin touch this surface,
NOTE: Do not let the point of needle or pin touch any part of the Spray Pad surface or Spray Pad will not spray solution properly,
SPRAY PORT
NEEDLE OR
PIN