CARPET PREPARATION
For best results prepare carpet for cleaning as follows:
1.Vacuum carpet to remove loose dirt before using Cleaner,
2.To remove stains and ground in dirt present in heavy traffic areas of the carpet, spray or rub Sears Heavy Traffic Fre-
Trealanent (82833) into carpet before using Cleaner. Follow directions on the bottle.
FILLING CLEANER WITH WATER AND
CLEANING SOLUTION
See Figure 4
1.Open lid of the Filler Opening.
2.Add Sears All In One Carpet Cleaner (82813) solution or Sears Upholstery Cleaner (82843) solution to Solution Tank
(depending on type of cleaning to be performed). Follow directions on label of bottle.
3.Pour clean, hot water (from tap) into Filler Opening in the Solution Tank
4.Close Filler Opening.
NOTE: This unit may become damaged if boiling water is used,
POWER CORD AND SWITCH
See Figure 5
1.Make sure Short Cord is plugged in as shown.
2.Plug Power Cord into electrical outlet.
3.Turn Power Switch to "ON" position,
PUMP SWITCH
See Figure 5
1.Place Pump Switch from "OFF" position to either "HI" or "LO" position.
NOTE: "HI" pump speed is used for normal cleaning. "LO" pump speed is used for delicate upholstery or light cleaning.
FILLER
OPENING
PUMP
SWITCH PUMP
CORD
POWER
SWITCH