Shark S3250CW manual Care of Your Light & Easy Steam Mop Trouble Shooting

Care of Your Light & Easy™ Steam Mop

Trouble Shooting	English
PROBLEM	POSSIBLE REASONS & SOLUTIONS
The Light & Easy™	Your steam-mop should be securely plugged into a
	120V AC electrical outlet only.
Steam Mop will not	Check your fuse or breaker.
turn-on.	If your unit still does not work, call 1-800-418-0934.

fig. 4

fig. 5

CARE OF YOUR MICRO-FIBER CLEANING PAD

1Wash pads in warm water. Wash separately from other laundry. Only use liquid detergent (no powder detergent). Do not use fabric softeners. Line dry or dry on a low dryer setting. (fig. 5)

2If there are loose threads on the pad carefully cut the threads with scissors. Do not pull on them or cut at the base. (fig. 6)

IMPORTANT: The micro-fiber cleaning pad may be very hot from the steam. Use caution when removing. Let the unit cool for 2-3 minutes.

ORDERING REPLACEMENT PARTS To order additional parts and accessories, feel free to contact us at www.sharkclean.com or call 1-800-418-0934.

NOTE: Some parts may be available

at your local retailer. Contact customer service for any other servicing.

Light & Easy™	Is there water in the water tank? If not, add water to your
Steam Mop will not
	Steam Mop following instructions on page 5.
make steam.
Light & Easy™	Is your micro-fiber cleaning pad too wet? Unplug your
Steam Mop leaves
	Steam Mop and change the micro-fiber cleaning pad.
water on the floor.
Light & Easy™	Do not leave your steam-mop on the floor with a damp or
	wet cleaning pad.
Steam Mop left	Do you have hard water? If you do, you might want to
white spot on the
	switch to distilled water.
floor.	Make sure the water is securely on the water tank.
	The pad might be dirty, change the pad.
	If you washed the pocket with powder detergent, then the
	pad may have residual detergent left on it. Wash it again
	with liquid detergent.
	If you are cleaning in a kitchen area where there might be a
Floors are cloudy,	build-up of grease, use a de-greasing agent such as an all-
	purpose cleaner or dish soap and paper towels to clean the
streaky or spotty
	area first.
after steaming.	You might have left the mop in the same spot for too long.
	Do you have hard water? If you do, you might want to
	switch to distilled water.
	This might be leftover from past cleaners used on the floor
	surface. Use the steam mop a few more times and see if
	the leftover cloudiness is removed.
Light & Easy™	Make sure the steam pad is attached correctly.
Steam Mop is hard	Check to see if the cleaning pad is excessively dirty.
to push.	Replace if the pad is too dirty or wet.

10 TOLL FREE: 1-800-418-0934

S3250CW_11_IB_ENG_100913.indd 10-11

www.sharkclean.com	11
10-09-13	10:57 AM