Sanitaire SC6090 Series General Information, Automatic Suction Shut-Off, Service Information

Page 3

GENERAL INFORMATION

Automatic Suction Shut-Off

NOTE: Use the vacuum in the upright position. If the cleaner should tip, the automatic suction shut-off turns off the suction.

The automatic suction shut-off functions when the tank is full of liquid. As the tank fills, the ball float (inside the cage) rises until it seats itself against the motor inlet. This shuts off the suction causing the motor sound to become higher in pitch. When this happens, empty the tank.

The automatic suction shut-off also functions if the cleaner tips over. To continue use, turn cleaner off and set it upright. Wait a few seconds to allow motor to come to a complete stop so the ball drops. Restart the motor.

Use this vacuum for wet pickup only.

Service Information

The instructions in this booklet serve as a guide to routine maintenance. For additional service information, telephone our toll free number for the nearest Sanitaire Authorized Warranty Station. You should know the model, type and serial numbers when you call:

USA: 1-800-800-8975

Mexico: 5670-6169

Canada: 1-800-800-8975

If you prefer, you can write to Electrolux Home Care Products North America, Service Division, 807 North Main Street, Bloomington, Illinois 61701, USA. In Canada, write to Electrolux Home Care Products Canada, 866 Langs Drive, Cambridge, Ontario N3H 2N7. Refer to The Sanitaire Commercial Equipment Warranty for complete service information.

DO NOT OIL the motors at any time. Bearings have a seal and are permanently lubricated.

Rating Plate

The model, type and serial numbers are on the rating plate, located on the back of the unit. For prompt and complete service information, always refer to these numbers when inquiring about service.

MODEL

TYPE

SERIAL NO.

VOLTS

AMPS.

HERTZ

SERVICE INFORMATION: 1-800-800-8975

BLOOMINGTON, ILLINOIS 61701

Model and Type:_________________________

1

Serial No._______________________________

IDENTIFY PARTS OF CARPET

EXTRACTOR CLEANER

3

Unpack powercord from carton and

 

remove Extractor.

 

1. Handle

 

2. Hose Inlet

 

3. Recovery Tank Lid

4

4. Solution Tank Lid

 

5. Drain Outlet

 

A. Drain Outlet Diverter

 

B. T-Handle

 

6. Solution Hose Connection

 

(with optional wand)

 

7. Rear Wheels

 

8. On/Off Switches

 

A. Suction Motor

7

B. Pump Motor

 

C. Brush Roll Motor

 

9. Cleaning Solution Button

 

10. Power Cord

 

11. Extension Cord

11

 

8

2

9

5B

5

5A

6

10

3

Image 3
Contents Index Grounding Instructions Important SafeguardsRating Plate Service InformationGeneral Information Automatic Suction Shut-OffOptional Extractor Wand Accessory Kits HOW to USETroubleshooting