Operations
Ready Tools™ continued
9. Clean by pressing the trigger to spray | 11. | 12. |
solution onto the area to be cleaned. Slowly |
|
|
move the tool back and forth over the soiled |
|
|
surface. Release the trigger to suction dirty |
|
|
water. Continue to clean in the area, work- |
|
|
ing in small sections, until dirt is removed. |
|
|
Caution: Do Not Overwet. |
|
|
10. When finished cleaning, remove and rinse tool(s) in clean, running water.
11.It is recommended that you suction clean
water from a bowl to rinse out the hose. |
| Run water through here | |
12. Before wrapping hose onto tool rack, lift end |
| ||
15. | 16. | ||
of hose and stretch out to ensure all water is | |||
|
|
cleared from hose.
13. | Wrap flex hose around tool rack. |
|
14. | Empty |
|
| following instructions on pages 9 through |
|
| 10. |
|
15. | If the ReadyTools dial becomes difficult to |
|
| turn, the diverter assembly that holds the | Screw |
| dial may need to be cleaned. To clean, | |
|
|
first remove nozzle and locate screw that holds the diverter assembly in place. With a Phillips screwdriver, remove the screw and set aside.
16.Remove diverter assembly; hold under run- ning water making sure water flows through and around the dial. Turn the dial about 10 times clockwise and 10 more times counter clockwise. This should free up any debris.
17.Wipe diverter assembly with a soft cloth and replace back on machine. Replace nozzle.
18.Return ReadyTools dial to FLOOR CLEANING setting.
11
w w w . b i s s e l l . c o m