Troubleshooting, Reduced Spray or No Spray

Troubleshooting

Reduced Spray OR No Spray

Possible causes

1.Bladder may be empty

WARNING:

To reduce the risk of fire, electric shock or injury, unplug from the outlet before servicing.

Remedies

1.Turn power switch OFF; Refill bladder with clean hot tap water.

2.2-in-1 tank may not be seated properly.

2.Turn power switch OFF; remove tank and reseat tanks.

3.Pump may have lost prime.

3.Turn power switch OFF; after 1 minute turn ON and depress spray release trigger.

4.The pump belt may be broken.

4. Turn power switch OFF and unplug from the outlet. To

check if a pump belt has broken, you will need a flat

Slots Pump Belt

head screwdriver.

A. Insert the blade end into the slot of the belt access

door to release. Examine the belt for breakage. You

should be able to see the pump belt looped around the

motor shaft. If it is broken or missing, please refer to

Replacement Parts on page 14. A replacement belt may

be ordered by calling BISSELL Consumer Services

Complete installation instructions will accompany the

replacement belt.

B. When replacing belt access door be sure to line up

slots of belt access door with slots in machine,

DirtLifter PowerBrush Does Not Turn

Possible causes

1.The brush belt or pump belt is off or broken.

Cleaner Not Picking Up Solution

Possible cause

1. ReadyTools dial may be on the wrong setting

slide door into place and snap shut.

Remedies

1.Refer to Remedy 4 above to check if brush belt or pump belt is broken.

Remedies

1.Set ReadyTools dial to either FLOOR CLEANING or TOOLS.for the cleaning job.

2.Poor tool position. (Hand held attachments only).

3.Removable nozzle may not be properly attached.

2.Adjust angle; apply more downward pressure.

3.Make sure nozzle is on correctly by slightly raising front of machine to line up slots on the base of the machine with the hooks on nozzle. Attach at base first and then click nozzle into place. Refer to image 5 on page 9.

4.2-in-1 tank lid is not properly installed.

5.2-in-1 tank is not properly seated.

4.Re-install lid; refer to the image on page 8.

5.2-in-1 tank must be firmly seated to function; remove and reseat 2-in-1 tank.

6. 2-in-1 tank has picked up maximum dirty water.

6.Empty 2-in-1 tank and refill, refer to the Operation section.

7. The lint screen may be clogged

7. Clean out lint screen. Refer to page 9.

Other maintenance or service not included in the manual should be performed by an authorized service representative.

Thank you for selecting a BISSELL product.

Please do not return this product to the store.

w w w . b i s s e l l . c o m