Bissell 1770 warranty Assembly, Operation, Before you clean, Fill the tank, Pre-Treating

Assembly

1.Slide upper body into lower body.

2.Secure with screws.

3.Slide handle assembly down into upper body until it will go no further. Align screw slots.

4.Secure with screw.

5.Place solution tank on back of unit.

Operation

Before you clean

1.

3.

2.

4.

1.Remove easily moved furniture (chairs, lamps, coffee/cocktail tables, etc.) from room if needed.

2.Vacuum carpet thoroughly.

3.Decide where to begin. Plan to leave a path open to empty soiled water and refill cleaner.

Note: Carpeting will dry in three to four hours, depending on carpet style and air circulation in room. A floor fan speeds drying

Fill the tank

1.Remove the solution tank by lifting it straight up, then away from the lower body.

2.Unscrew the black cap at the bottom of the solution tank.

3.Fill to the FORMULA line with BISSELL 2X Fiber Cleansing formula. Fill the rest of the tank with hot (not boiling) tap water to the water fill line. Replace and tighten the black cap.

4.Place solution tank on lower body.

5.Rotate Quick Release Cord Wrap™ to release the power cord and plug into an outlet.

Pre-Treating

Pre-treat stubborn stains and highly soiled carpet in hallways and other high-traffic areas.

1.Generously spray BISSELL Tough Stain pre-cleaner evenly over soiled area. DO NOT OVERWET CARPET

2.Wait 3-5 minutes before deep cleaning.

Tip:

Deep cleaning spots, spills and high traffic areas on a regular basis can prolong carpet life.

WARNING:

To reduce the risk of fire, use only BISSELL advanced cleaning formulas for deep cleaning machines. Use of cleaning formulas that contain lemon or pine oil may damage this appliance and void warranty. Chemical spot cleaners or solvent- based soil removers should not be used. These products may react with the plastic materials used in your QuickSteamer, causing cracking or pitting.