Bissell 1770 warranty Hard floor cleaning, Cross action brush

Operation

Hard floor cleaning

(included on select models only)

1.Remove the collection tank (refer to steps 2a and b in the "To empty the collection tank" section on page 6)

A.For 1770/1970 series it is necessary to remove the cross action brush first. Using your thumbs squeeze the 2 grey tabs towards the outside of the unit. Push down at the same time and release

the cross action brush.

2.Attach the hard floor tool by hooking it into the front of the removable nozzle and swinging it down until the tabs pop into place.

3.Replace the collection tank. Be sure to attach the two latches.

4.Fill solution tank with BISSELL 2X Hard Floor Solutions™ to FORMULA fill line. Fill the rest of the tank with hot (not boiling) tap water to the WATER fill line. Replace and tighten the black cap.

5.Follow steps 1-8 in "Carpet Cleaning" section above.

WARNING:

To reduce the risk of fire and electric shock- when cleaning a hard floor, the BISSELL hard floor tool 203-5637 (models 1770 & 1970) / 203-5639

(models 2080 & 2090) must be used and it must only be used with BISSELL Hard Floor Solutions or BISSELL 2X Hard Floor Solutions cleaning fluid intended for use with this appliance.

2.