Bissell 1718, 1719 warranty Troubleshooting, Machine storage, Reduced Suction / No Suction

Maintenance and care

Machine storage

1.Clean exterior surface of Spot Lifter with a soft cloth dampened with water only. Do not use a strong detergent or other cleaners as this may damage the finish.

2.Store Spot Lifter in a protected dry area, at room temperature (40° - 110°F).

1.Important: Unplug charger.

2.Remove tanks (front and rear) and discard.

3.Remove screws (6) holding product housing together.

4.Use screwdriver to score rating label on bottom of unit.

5.Separate housings and locate battery pack in bottom/ center of unit.

6.Remove wire connectors from the battery pack.

7.Keep battery pack together - DO NOT separate individual batteries. For specific disposal instructions of batteries, please contact:

RBRC (Rechargeable Battery Recycling Corporation) 1-800-723-1297

or visit www.rbrc.com .

8.Discard remainder of product.

Troubleshooting

Reduced Suction / No Suction

Possible Cause

1.Collection tank is full

2.Collection tank drain plug is loose

3.Batteries weak/undercharged

4.Collection tank not properly installed

WARNING:

This product contains a rechargeable nickel cadmium battery (sometimes referred to as a “Ni-Cad” battery) pack. The average life of a Ni-Cad battery is 5-7 years, depending on frequency of use. According to Federal regulations, proper removal and disposal of Ni-Cad batteries is required.

3.

Screws

WARNING:

To reduce the risk of fire, electric shock or injury, unplug appliance from outlet before servicing.

Remedies

1.Empty collection tank

2.Check plug for snug fit

3.Recharge according to instructions

4.Snap tank into place