Bissell 1718, 1719 Pre-treating, Cleaning, Spot cleaning upholstery, Turn power switch I on

Operations

Pre-treating

1.Turn power switch “I” (ON).

2.To pre-treat stained or highly soiled areas, hold Spot Lifter above soiled surface and press trigger to spray cleaning solution.

3.Let cleaning solution set for 3-5 minutes before cleaning.

Cleaning

1.Turn power switch “I” (ON).

2.Hold Spot Lifter above soiled surface and press trigger to spray cleaning solution, as in pre-treating step 2 above.

3.Press front of Spot Lifter firmly against surface and pull toward you to remove cleaning solution and soil.

4.Repeat steps 2 and 3 until no more dirt or cleaning solution can be removed. Do not overwet.

5.For stubborn soil, use brush to gently scrub soiled area while continuing to spray cleaning solution. To remove brush from unit, gently pull on brush tab and lift out.

NOTE: If Spot Lifter stops spraying,

turn “ O ” (OFF) power switch and check cleaning solution level. Refill if needed. Never run dry.

Spot cleaning upholstery

1.Check manufacturer’s tag before cleaning. “W” or “WS” on the tag means you can use your Spot Lifter. If tag is coded with an “S” (with diagonal strike-through), or says “Dry Clean Only,” do not proceed.

2.If manufacturer’s tag is missing or not coded, check with your furniture dealer.

NOTE: If possible, check upholstery stuffing. Colored stuffing may bleed through fabric when wet.

2.

Tip:

Immediate attention to a spill on upholstery can prevent permanent staining.

3.5.

Tip:

Use the brush after applying cleaning solution and remove any surface soil. Using the brush before applying solution can push soil more deeply into carpet.

Manufacturer’s Tag

w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1 7