Using Your Steam Cleaner
!CAUTION
After plugging in the power cord and beginning to heat, a fixed amount of water is released due to the
Fig 9
Fig 10
Control
Trigger
Fig 11
Lock for
Continuous
Steam
!CAUTION
Pressure always exists within the product. Make sure to press the Control Trigger to eliminate this pressure prior to opening the safety cap.
Operating the Steam Cleaner:
NOTE: Your Steam Cleaner is designed to clean hard surfaces and upholstery that will withstand high heat. DO NOT use on soft plastic and cold glass. On surfaces that have been treated with wax, or on some
7)If using the Steam Cleaner for the first time, fill the tank and then discard this water. Refill the tank with fresh water There may be a slight odor emitted on the first use.
8)Once you have attached the accessory that suits your need and filled the unit with water, plug the unit into a grounded outlet. The green ‘POWER’ light will come on. (Fig 9)
9)Wait
10)Steam will emit from the nozzle every time the trigger is pressed and/or held down. To access continuous steam, just slide the ‘Continuous Steam Lock’ into the Locked position. (Fig 11) The steam pressure will be affected and will become low after a fixed amount of time. Use the MicroCham™ towel to absorb any surface moisture.
Refilling Water Tank During Use:
11)When you no longer have steam emitting from the nozzle, this signifies that there is no more water in the Water Tank. The ‘Steam Ready’ light will also go out when the tank is empty.
12)To refill the water tank, first unplug the power cord, and press the Control Trigger to fully release all steam remaining inside the tank.
13)Wait at least three minutes before opening the safety cap to allow the pressure to dissipate.
pg 8 | 877 - HAAN DIRECT / 877 - 422 - 6347 | www. haanusa . com |