Please unpack and identify the following parts

The Specialist In Drum Handling Equipment

MODEL 400A-60

Hydra-Lift, 60”, Manual Lift, Manual Tilt

Assembly Instructions for Morse Hydra-Lift Drum Karrier Model 400A-60

Serial Number 0604 to ____ (MMYY)

Step #1: Place tower on floor, push-handle down. See figure 1.

Step #2: Attach each leg (item 4) using two 3/8-16x3” grade 5 bolts (item 2), flat washers (item 3), and lock nuts (item 13) as shown. Wheels should be parallel when assembled properly. See figures 1 & 2.

Please unpack and identify the following parts:

1 ea. Tower with hydraulic pump and cylinder, etc.

2 ea. Legs with wheels

1 ea. Overhead assembly with drum holder, etc.

1 ea. Package with hardware

NOTE: The clevis pins and mating surfaces at their joints should be coated with grease during assembly.

FIGURE 1

FIGURE 2

Step #3: Tip the tower up so it stands on the casters and wheels.

Step #4: Lift overhead assembly into position. A drift pin can help align the holes. Insert a greased clevis pin (item 12) through mast cap and boom. Install a 5/8” washer (item 9) and 3/16” roll pin (item 8) in the end of the clevis pin. See figure 3.

Step #5: Next, connect the cylinder (item 16) to the overhead assembly: Align ram eye with holes in boom clevis plates and insert a greased clevis pin (item 12) with four 5/8” washers (item 9). Place another washer (item 9) on outer end of clevis pin and drive a 3/16” roll pin (item 8) into the hole at the end of clevis pin. See figure 4.

FIGURE 3

FIGURE 4

Step #6: Remove sealing plug from the top of hydraulic reservoir and fill reservoir with included container of hydraulic fluid. Replace sealing plug with the included breather plug. Your Hydra-Lift Karrier is now ready for service. Please refer to the operating and maintenance instructions provided.

Form PL400-60 (0604-____) (Updated 10/2007)

Page 5