Installation

DIFFERENT WAYS TO

INSTALL YOUR

AQUAGUARD CLASSIC-

PUMP MODEL

The ideal place for your Aquaguard Classic is above the kitchen sink.

Your Aquaguard Classic can be fitted on the wall through key slots provided at the back.

Your Aquaguard Classic will be installed free of cost by our experienced Service Representatives.

You will require a standard 220/230 V supply and a

5 Amp. point. This should be a three pin type and properly earthed. One end of the water drawing pipe should be connected to the Aquaguard Classic and the other end of the pipe should be inserted into the container. Aquaguard Classic-Pump Model can not only be used to pump water from a storage container or vessel for the normal usage but also can be used for pre-cooler installation (along with water level controller).

Note: Kindly ensure that the source (storage container) has enough water before

you switch on your Aquaguard Classic.