AVR 1650/AVR 165
Troubleshooting
Troubleshooting
Symptom | Cause | Solution |
|
|
|
Unit does not function when Main Power switch is | • No AC power | • Ensure that the power cord is plugged into a live AC |
turned on |
| power outlet |
|
| • Check if the AC outlet is |
|
|
|
• Intermittent input connection | • Secure all input and speaker connections | |
sound or picture | • Mute is on | • Press Mute button |
| ||
| • Volume control is turned down | • Turn up Volume control |
|
|
|
No sound from any speaker; PROTECT message | • Amplifier is in protection mode due to possible short | • Check all speaker wires at speaker and AVR |
appears on Message display | circuit | connections for crossed wires |
| • Amplifier is in protection mode due to internal problems | • Contact your local Harman Kardon service center |
|
|
|
No sound from center or surround speakers | • Incorrect surround mode | • Select a surround mode other than stereo |
| • Program material is monophonic | • Mono programs contain no surround information |
| • Incorrect speaker configuration | • Check the speaker configuration in the setup menu |
| • Program material is stereo | • The surround decoder may not create center- or |
|
| |
|
| programs |
|
|
|
Unit does not respond to remote control commands | • Weak batteries in remote | • Change batteries in remote |
| • AVR not selected | • Press the Setup/AVR button |
| • Remote sensor is obscured | • Ensure that the AVR’s |
|
| the line of sight of the remote |
|
|
|
Intermittent buzzing in tuner | • Local interference | • Move the AVR or antenna away from computers, |
|
| fluorescent lights, motors or other electrical appliances |
|
|
|
Unable to activate remote control Programming mode | • Source Selector button is not held for at least 3 seconds | • Be sure to hold the Source Selector button for at least |
|
| 3 seconds |
|
|
|
Additional information on troubleshooting possible problems with your AVR and
25