Rear Panel Connections

™

∞

•

‚

SUBWOOFER

LEVEL

FILTER

MIN MAX

OFF

AUTO

PHASE

REVERSE

NORMAL

SUB RL

LINE

LEVEL

OUTIN

IMPORTANT: CONNECT STRIPED WIRE TO RED () SPEAKER TERMINAL.

SUB-TS11For use with

HKTS 11 System

"WARNING: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME TYPE T 2.5A L/250 VOLT FUSE"

"AVERTISSEMENT: UTILISEZ UN FUSIBLE DE RECHANGE DE MEME TYPE T 2.5A L/250V"

POWER

AC 230V~50Hz

Subwoofer-Level Control

High-Cut (Low-Pass) Filter Switch

Music-Sense On/Off Switch

Phase Switch

Line-Level Subwoofer (SUB) Input	Master Power Switch
Line-Level Full-Range Inputs	AC Power Cord
Speaker-Level Outputs
Speaker-Level Inputs

Subwoofer-Level Control: Volume

may be adjusted using the Subwoofer-Level Control. Turn the control clockwise to increase the SUB-TS11’s volume, or counterclockwise to decrease it.

High-Cut (Low-Pass) Filter Switch: Plac-

ing this switch in the ON position activates cir- cuitry that cuts out all audio input signals above 120Hz. This allows the SUB-TS11 to focus its power on reproducing the low-frequency portion of the signal, avoiding inefficiency and distor- tion. Engage this filter when using the Speaker- Level Inputs , or when using the Line-

Level Full-Range Inputs , unless your

receiver or processor processes its line-level out- put using a low-pass filter. The filter has no

effect when the Sub Input

is used.

Music-Sense On/Off Switch: When placed in the AUTO position, and when the Master Power Switch is turned on, the SUB-TS11 will automatically turn itself on or place itself in the Standby mode, depending on whether it is receiving an audio signal. When this switch is placed in the ON position, the SUB-TS11 will remain on, whether or not it is receiving an audio signal.

An LED located on top of the SUB-TS11 indi- cates whether the SUB-TS11 is in the On or standby state when used with the Music-Sense On/Off Switch in the AUTO position. The LED is lit blue to indicate that the SUB-TS11 is receiving an audio signal and is turned on, and the LED is lit amber to indicate that no signal is being received and the SUB-TS11 is in Standby mode.


When the Music-Sense On/Off Switch		is
in the ON position, the LED will be lit blue,
whether or not an audio signal is present.
When the Master Power Switch	is turned

off, the LED goes dark, no matter which position

the Music-Sense On/Off Switch

is in.

Phase Switch: This switch determines

whether the SUB-TS11 subwoofer’s piston-like action moves in and out in phase with the main speakers. If the speakers were to play out of phase, the sound waves produced by the sub- woofer would be cancelled out, reducing bass response. This phenomenon depends in part on the relative placement of the speakers in the room. In most cases, the Phase Switch should be left in the NORMAL position. How- ever, it does no harm to experiment with the Phase Switch , and you may leave it in the position that maximizes bass response.

4REAR PANEL CONNECTIONS