GE 3020511 installation manual Troubleshooting, Problem Possible Cause Solutions

			Brine Valve PN 3020511
Troubleshooting
	Problem	Possible Cause	Solutions
	No water refill into the	Brine valve not operating	Check that the brine valve is vertical and
	salt tank		moving freely.
			Water flow is greater than 1.2 gpm
			(4.5 L/m). Replace the refill control
			washer with a smaller inside diameter
			washer.
			Check to see if there is too much air in
			the resin tank.
		Obstruction in regenerant tube or valve	Inspect pipline, remove any debris.
		Damaged brine valve	Replace brine valve.
	Excessive refill	Seal leak or failure	Check for debris on seal.
			Replace the seal.
		The float does not close off incoming water	Float is restricted by the bracket. Raise
			top bracket to allow more space for float
			movement .
		Damaged brine valve	Replace brine valve.
	System uses less brine	Air leak	Inspect pipeline and repair leaks.
	than the regnerate
		Regenerant tube is too long	Be sure the length is less than 6.6 ft (2 m).
	setting
		Brine valve is set incorrectly	Check and adjust floater to appropriate
			height.
			Be sure the refill controller is an
			appropriate size.
		The check ball was pulled at wrong time	Remove the check ball enclosure.

3