Harman-Kardon 13828 owner manual Front Panel Controls, Tuning Tuner Band Selector

Front Panel Controls

D F 5 J I

DIGITAL	LOGIC 7	VID	1	DVD
PRO LOGIC		VID	2	CD
3 STEREO	DSP	VID	3	FMAM
	5 CH. STEREO			TAPE
	SURR. OFF			6 CH

1 2 6

7 8	E	B	G
C	9	A 3 4	H

Main Power Switch

1System Power Control

2 Power Indicator

3 Headphone Jack

4 Digital Optical 3 Input

5 Speaker/Channel Input Indicator

6 Surround Mode Group Selector

Main Power Switch: Press this button to apply power to the AVR. When the switch is pressed in, the unit is placed in a Standby mode, as indicated by the orange LED 2. This button MUST be pressed in to operate the unit. To turn the unit off completely and prevent the use of the remote control, this switch should be pressed until it pops out from the front panel so that the word “OFF” may be read at the top of the switch.

NOTE: This switch is normally left in the “ON” position.

7Tuning

8Tuner Band Selector

9 Preset Stations Selector A Input Source Selector B RDS Select Button

C Surround Mode Selector D Surround Mode Indicators

1System Power Control: When the Main Power Switch is “ON,” press this button to turn on the AVR; press it again to turn the unit off (to Standby). Note that the Power Indicator 2 will turn blue when the unit is on.

2Power Indicator: This LED will be illuminated in orange when the unit is in the Standby mode to signal that the unit is ready to be turned on. When the unit is in operation, the indicator will turn blue.

3Headphone Jack: This jack may be used to listen to the AVR’s output through a pair of headphones. Be certain that the headphones have a standard 6.3 mm stereo phone plug. Note that the speakers will automatically be turned off when the headphones are connected.

4Digital Optical 3 Input: Connect the optical digital audio output of an audio or video product to this jack. When the Input is not in use, be certain to keep the plastic cap installed to avoid dust contamination that might degrade future performance.

ERemote Sensor Window F Main Information Display G Digital Coax 3 Input H Video 3 input jacks

I Volume Control J Input Indicators

5Speaker/Channel Input Indicators: These indicators are multipurpose, indicating either the speaker type selected for each channel or the incoming data-signal configuration. The left, center, right, right surround and left surround speaker indicators are composed of three boxes, while the subwoofer is a single box. The center box lights when a “Small” speaker is selected, and the two outer boxes light when “Large” speakers are selected. When none of the boxes are lit for the center, surround or subwoofer channels, no speaker has been selected for that position. (See page 16 for more information on configuring speakers.) The letters inside each of the center boxes display active input channels. For standard analog inputs, only the L and R will light, indicating a stereo input. When a digital source is playing, the indicators will light to display the channels begin received at the digital input. When the letters flash, the digital input has been interrupted. (See page 15 for more information on the Channel Indicators).

8FRONT PANEL CONTROLS