Controls and Functions
|
|
|
|
|
| ENGLISH | ||
|
|
|
|
|
|
| ||
|
|
|
1Power Indicator: This LED will illuminate in amber when the unit is in the Standby mode to signal that the unit is ready to be turned on. When the unit is in operation, the indicator will turn blue.
2System Power Control: Press this button to turn on the HK 980; press it again to turn the unit off (to Standby). Note that the Power Indi- cator 1 next to the switch will turn blue when the unit is on.
3Speaker 1/2 Selectors: Press to select speaker pair 1 or 2, or both, or neither (head- phone output only).
4Input Source Selector: Select desired input source for listening by
5Record Source Selector: Select desired source for recording to device connected to the rear panel Tape and CDR Out sockets by pressing the ”Record Source” button repeatedly until the display for the desired source is illuminated.
6Source Direct: Press to bypass tone control circuitry.
7Mode Button: Press this button to make changes to the bass, treble and balance settings.
8Headphone Jack: Plug in headphones if desired. With both ”Speaker 1” and ”2” selec- tors in the Off position, output is supplied only to headphones.
9Volume Control: Turn to raise or lower out- put volume.
)Main Information Display: This display delivers messages and status indications to help you operate the receiver.
!Remote Sensor Window: The sensor behind this window receives infrared signals from the remote control. Aim the remote at this area and do not block or cover it unless an external remote sensor is installed.
CONTROLS AND FUNCTIONS 5