Kenmore 625.384600 owner manual Parts of the System, Materials and Tools Needed

Page 4

PARTS OF THE SYSTEM

filter system assembly including mounting brack- et and screws

water supply fitting

_" filtered water faucet for sink or countertop mount- ing

3/8" tubing to make all needed connections

MATERIALS AND TOOLS NEEDED

• plumbers putty

• slotted and Phillips screwdrivers

•pliers and adjustable jaw wrench

•tubing cutter

•sandpaper or emery cloth

•electric driU and 3 / 4" d_l bit if mounting hole is needed for the faucet, see page 6

CAUTION: To avoid damaging the sink, consult a

qualified plumber or installer for dialing procedures

in porcelain or stainless steel.

TYPICAL UNDERSINK INSTALLATION

FIG. 1

shutoff valve

Note: To change the fil- ter cartridge, you must turn off the water and re- tease pressure by open- ing the faucet. A nearby shutoff valve is conve* nient. Most sinks al-

ready have shutoff

valves on the supply pipes.

faucet

filtered water

supply fitting

\

\

WATER

IN

mounting screw (2)

\

$

Filter I

Filter II

Note: Be sure to allowa minimumspaceof 1-1/2" under the system for removing the sump& to change the cartridges.

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Undersink Drinking Water Filter System Safety Guides / Specifications WarrantyTable of Contents Parts of the System Typical Undersink InstallationMaterials and Tools Needed Installation Steps Cold Water Supply FittingWater Supply Fitting Optional Pipe FittingsMake Hole for Filtered Water Faucet Assemble Install FaucetNot to Cross Thread Make Tubing Connections Filter Cartridge InstallationIts held firmly in the fitting Using System Filter Cartridge / Useful Life / ReplacementCountertop Faucet WaterFilter Cartridge Replacement Clockwise the sump onto the filter head and tightenRepeat steps 2 through 7 at the other filter Taste and Odor Cartridges a taste and odor carRepair Parts Repair Parts List 7161255Model no
Top Page Image Contents