Installation and Connections
15
NOTE: While most speaker manufacturers adhere to an industry convention of using black terminals for negative and red ones for positive, some manufacturers may vary from this configuration. To assure proper phase, and optimal performance, consult the identification plate on your speaker, or the speaker’s manual to verify polarity. If you do not know the polarity of your speaker, ask your dealer for advice before proceeding, or consult
the speaker’s manufacturer.
7.Connections to a subwoofer are made via a line level audio connection from the Subwoofer Output » to the line level input of a subwoofer with a
Video Equipment Connections
Video equipment is connected in a fashion similar to audio components. Again, the use of
1.Connect a VCR’s audio and video Play/Out jacks to the Video 1 In jacks £ on the rear panel. The audio and Record/In jacks on the VCR should be connected to the Video 1 Out jacks ¢ on the AVR65.
2.Connect the audio and video outputs of a satellite receiver, cable TV converter or television set or any other video source to the Video 2 In jacks ß.
3.Connect the audio and video outputs of a DVD or laser disc player to the DVD jacks ¦.
4.Connect the TV Monitor Out à jacks on the receiver to the video input of your television monitor or video projector.
NOTE: The AVR65 will accept both stan- dard (composite) or
System and Power Connections
The AVR65 is designed for flexible use with external control components and power amplifiers. These connections are easy to make during an initial installa- tion, or at a later date should you choose to upgrade your system.
Remote Control Extension
If the receiver is placed behind a solid or smoked glass cabinet door, the obstruc- tion may prevent the remote sensor from receiving commands. In this event, an optional remote sensor may be used. Connect the output of the remote sensor to the Remote Cont. In jack a.
If other components are also prevented from receiving remote commands, only one sensor is needed. They may use this unit’s sensor or a remote eye by running a connection from the Remote Cont. Out jack b to the Remote In jack on Harman Kardon or other compatible equipment.
External Audio Power Amplifier Connections
If desired, optional external power audio power amplifiers may be used with the AVR65. Connections to these amplifiers are made by using audio interconnect cables connected to both the Preamp Outputs ¥ on the rear panel and the audio input jacks of the external amplifiers.
External Audio Decoder Connection To provide for the ultimate flexibility, the AVR65 may be used in conjunction with optional, external decoders for digital audio systems other than the AVR65’s
own
These jacks may also be used for connec- tions to devices such as DVD players or High Definition Television (HDTV) sets or decoders that feature
AC Power Connections
This unit is equipped with two accessory AC outlets. They may be used to power accessory devices, but they should not be used with
The Switched Ý outlet will receive power only when the unit is on. This is recommended for devices that have no power switch, or a mechanical power switch that may be left in the “ON” position.
NOTE: Devices with electronic power switches may only go into a Standby mode when plugged in here.
The Unswitched Ü outlet will receive power as long as the unit is plugged into a powered AC outlet.
Finally, when all connections are com- plete, plug the power cord into a non- switched
AVR65 120 volt Rev (C) 10/6/98