Installation

If the mounting surface is less than 3/16” thick, care- fully trim the spacer ring so that it is even with the bottom of the faucet.

If the mounting surface is greater than 3/16”, leave the spacer ring intact.

Place the mounting plate over the stud. Tighten the collar so that it is snug against the bottom of the mount- ing surface.

Install the supply hoses to the stops with the compres- sion fittings, taking care not to twist the supply hoses.

Install the pop-up drain.

Re-set the high temperature limit stop.

Turn on the water and test all connections for leaks.