Note: Performance of this tool (if powered by line voltage) may vary depending on variations in local line voltage. Extension cord usage may also affect tool performance.
Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking your AM/FM Band Radio, check to make sure that all parts listed in the parts list on page 10 are included. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at
Assembly
Your Radio comes completely assembled. The only assembly required is installation of the back up batteries.
Installing the Back Up Batteries
1.Remove the Battery Cover
2.Insert two “AA” Batteries as marked on the inside of the battery compartment.
3.Set the Battery Selector Knob to
Operation
Using the
1.Set the Battery Selector Knob to “Generated”.
2.Pull out the
3.To charge the Radio, turn the Handle rapidly clockwise. Note that turning the Handle for one minute will give you about 30 minutes of listening time.
4.Note that when turning the Handle to recharge the batteries, if the radio is on, noise interference may occur.
5.The Handle must be turned rapidly in either direction to fully and efficiently recharge the batteries.
6.The rechargeable
7.To maintain optimal battery life, discharge the batteries completely before recharging.
8.Only recharge the internal batteries when the “Low Battery Indicator Light” comes
SKU 94670 | For technical questions please call | Page 7 |