Briggs & Stratton 294700, 303700, 350700, 290700 warranty Engine and Engine Parts

Page 13

MAINTENANCE

ENGINE AND ENGINE PARTS

We recommend that you see an authorized Briggs & Stratton Service Dealer for all maintenance and service of the engine and engine parts. Use only genuine Briggs & Stratton parts.

WARNING

WARNING

If you perform any maintenance on the engine, first disconnect the spark plug wires from the spark plugs, and disconnect the battery at the negative terminal (electric starter engines only) to prevent unintentional sparking. Unintentional sparking can result in fire or electric shock. Unintentional start-up can result in entanglement, traumatic amputation or laceration. Use only correct tools.

Do not strike the flywheel with a hammer or hard object because the flywheel may later shatter during operation.

Do not tamper with governor spring, links or other parts to increase engine speed.

MUFFLER

Replacement parts for the WARNING muffler must be the same and installed in the same position

as the original parts, other- wise fire can occur.

If muffler is equipped with spark

arrestor screen, remove screen for inspection. Replace screen if damaged or plugged.

AIR COOLING SYSTEM

Debris may clog the engine’s air cooling system. Remove blower housing and clean area shown to prevent overheat- ing and engine damage.

FUEL SYSTEM

WARNING

Replacement parts for fuel system (cap, hoses, tanks, filters, etc.) must be the same as original parts, otherwise fire can occur.

CLEAN AREAS

OF ALL DIRT AND DEBRIS

FUEL FILTER (IF EQUIPPED)

FILTER

FILTER

SPARK PLUG

Use only Briggs & Stratton Spark Tester (part number 19368) to check for spark.

PART NO. 493629

PART NO. 298090 or 5018

(WITH FUEL PUMP)

(WITHOUT FUEL PUMP)

Note: In some areas, local law requires using resistor

.030” (0.76 mm)

WIRE GAGE

WARNING

[1]

Disconnect

spark

plug

 

wires and

keep

away

 

from spark plugs.

 

[2]

Drain fuel tank or close

 

fuel shut-off valve before

 

replacing

fuel

filter.

spark plug to suppress igni- tion signals. If this engine was originally equipped with resistor spark plug, use same type for replacement.

RESISTOR P/N 491055

RESISTOR P/N 496018

Otherwise, fuel can leak

out, creating a fire/explo-

sion hazard.

VALVE CLEARANCE

Check valve clearance yearly. (See Tune-up Specifications on page 6).

13

Image 13
Contents Table of Contents Operating & Maintenance InstructionsPower in Power EQUIPMENT Before Operating Engine Hazard Symbols and MeaningsSafety Broken bones, fractures, bruises or sprains could result Engine Model Engine PartsModel Series OIL Capacity OILType of OIL to USE Checking and Adding OILFuel OIL Pressure SwitchStarting Type of Fuel to USERewind Manual Starter Starting and StoppingTo Start Engine To Stop EngineElectric KEY Starter if equipped Maintenance MaintenanceEmission Control Changing OILCleaning PRE-CLEANERS and Cartridges AIR CleanerRemoving and Installing AIR Cleaner Changing OIL FilterEngine and Engine Parts Control Adjustments AdjustmentsCleaning Debris To Adjust Remote Choke ControlTo Adjust Remote Throttle Control Carburetor AdjustmentTo Adjust Carburetor Service Service & StoragePartial List of Genuine Briggs & Stratton Parts StorageBriggs & Stratton Emission Control Defects Warranty Coverage Normal wear Improper maintenanceBriggs & Stratton Engine Owner Warranty Policy