American Standard 2506, 192, 195 installation instructions Unit #1 Unit #2, Unit #3, Multi HOOK-UP

Fig. 2

Unit #1

1

	Unit #2
4	9
	TWO PIECE
	GROMMET
	3
3
	2

Unit #3

10

4

6

3

1

1 1

4"

5

1

2FOR AC-VERSION

(MULTI HOOK-UP); Fig. 2, 3

1.See AC Version Electrical Hook-up for first unit of the Multi hook-up.

2.Remove ENCLOSURE COVERS from all

ENCLOSURES.

3.Remove SOLID BLACK INSERT(1) from right side of ENCLOSURE #1 and replace with gray 2-PIECE GROMMET (3). Replace solid black inserts on Unit #2 with gray 2-PIECE GROMMET (3).

4.Take the 10 ft. EXTENSION (2) from Unit #2 and install into right side of Unit #1 and Left side of Unit #2 insealing wire into SPLIT PLUG (7) as shown in Fig. 3a. Push SPLIT PLUG (7) into GROMMET (8).

5.Insert CONNECTOR from 10 ft. EXTENSION (2) into CIRCUIT BOARD RECEPTOR (4) top of Unit #1 as shown in Fig. 2.

6.Insert other end of 10 ft. EXTENSION into LOWER U GROMMET (5) of Unit #2 (approximately 4" from connector). Fig. 3. Push SPLIT PLUG (7) into GROMMET (8) to seal.

7.Insert connector of 10 ft. EXTENSION into lower receptor as shown in fig. 3 on CIRCUIT BOARD (6) of Unit #2.

8.Feed gray sensor wire 9 from Unit #2 through upper U GROMMET (10) of Unit #2 ENCLOSURE 4" from connector Fig. 3. Insert wire into SPLIT PLUG (7). Push SPLIT PLUG (7) into GROMMET (8) to seal. Fig. 3a.

9.Insert GROMMET (2) back into ENCLOSURE. Fig. 3b.

10.Reinstall Circuit Board (3) into Enclosure with all wires under Board. Fig. 3b.

11.Connect Unit #2 Red and Black Sensor wires To #2 solenoid valve (Red to +, Black to -). Fig. 3b.

12.Repeat Steps 3 through 11 for remaining Units in Multi Hook-up.

Fig. 3a

TWO PIECE

GROMMET 8

7

2

Feed the gray 8 ft. EXTENSION (2) through ROUND

GROMMETS (3) and U GROMMETS (5) as illustrated above.

Fig. 3b

2

1 RED

3

BLACK

5 M 9 6 5 2 74