American Standard 192, 2506, 195 Mount Enclosure Fig, Connect Spout Hose to Enclosure Fig

2 MOUNT ENCLOSURE; Fig. 2

1. Determine location of ENCLOSURE (1). It must be

located with-in the 14" (356mm) by 21" (533mm)

shaded area shown in Figure 2 in order for electrical

connections from the spout assembly to be made.

NOTE: ENCLOSURE SUPPLY HOSE is 20". Distance

between wall supply and ENCLOSURE (1) must be

taken into consideration.

2. Remove 4 screws from COVER (2) and pull off

COVER (2). Hold the ENCLOSURE (1) in desired

location and mark the four mounting hole locations as

shown. Fig. 2.

Fig. 2

SUPPLIES 1

WASTE 20" (500mm)

21" (mm)

MOUNTING HOLES

LAVATORY RIM OR

MOUNTING SURFACE

14"

(356mm)

ENCLOSURE

MOUNTING HOLES

2-3/4"

(71mm)

3" 3-3/4"

(76mm) (96mm)

3. The ENCLOSURE (1) works best if secured to a wall

stud or cross brace within the wall, using the SCREWS

(3) supplied. If the ENCLOSURE (1) is to be installed on

a tile or plaster wall the ANCHORS (4) and SCREWS

(3) should be used.

4. For installations on drywall or tiled walls; use

ANCHORS (4) and SCREWS (3) for securing

ENCLOSURE (1) to finished wall. Drill four 1/4" dia.

holes a minimum of 1-3/4" deep. Insert the four

ANCHORS (4) flush with face of the finished wall.

Align the ENCLOSURE (1) and Install the MOUNTING

SCREWS (3). Tighten to secure ENCLOSURE (1) to

mounting surface.

3CONNECT SPOUT HOSE TO ENCLOSURE; Fig. 3

1.Connect SUPPLY NUT (1) from spout assembly to nipple on top of ENCLOSURE (2). Tighten with adjustable wrench to make a water tight connection.

Fig. 3.

4CONNECT WATER SUPPLY TO ENCLOSURE AND WALL SUPPLY; Fig. 4

NOTE; If using the optional Mixing Valve See Sheet #M968808 for installation instructions.

1.Insert FIBER WASHER (4) into SUPPLY NUT (1) on ENCLOSURE (2).

2.Connect SUPPLY NUT (1) on ENCLOSURE (2) to FLEXIBLE SUPPLY HOSE (3). Tighten to make a water tight connection. Use two wrenches to tighten if necessary. Fig. 4.

3.Connect FLEXIBLE SUPPLY (3) directly to wall supply. Connection on FLEXIBLE SUPPLY (3) is 3/8" compression. Use adjustable wrench to tighten connection. Do not over tighten. Fig. 4a.

Note: FLEXIBLE SUPPLY (3) measures 20" from the bottom of the ENCLOSURE (1) base. If additional supply length is required, installer must purchase parts separately.

Important: If FLEXIBLE SUPPLY (3) is too long, loop to avoid kinking.

3

1

2 4

1

NOTE: If using Mixing Valve (optional) See Sheet #M968808 for installation instructions.

Fig. 3	1
	2

Fig. 4

2	1	DO NOT USE PIPE
		SEALANT ON THREADS

4

3

Fig. 4a

4" ELECTRICAL BOX

OR EQUIVALENT BY OTHERS

COLD WATER OR 3 TEMPERED

WALL SUPPLY

3 M 9 6 5 2 74