Frigidaire FSC18CH8MV, FSC12CH8MV, FSC24CH7M, FSC24CH8M, FSC09CH8MV Remote control operations

Remote control operations

TEMP Button V : Push this button to decrease the indoor temperature setting.

.MODE: Each time the button is pressed, the operation mode is shifted in the direction of the arrow:

AUTO _ COLL I_ DRY I_ HEAT I_ FAN

t

*Note:COOL only model has no HEAT feature.

Display: cooling model Display: coolinglheating model

SWING: Push this switch button to change the louver angle.

ECONOMIC: When you push ECONOMIC button during cooling, heating (cooling only type without), or AUTO operation, the air conditioner wil! start following operation. The fan speed will be automatically controlled. In the operation suppression zone where capacity is kept to the minimum, overcooling is prevented by raising the temperature setting by 1°C after 1 hour and by 2°C after 2 hours of operation. The room temperature is thus regulated between the operation suppression zone and the set temperature. (it depends on the outdoor temperature.)

RESET: When you press the recessed RESET button, all current

settings are cancelled and the control wilt return to the initial

settings.

AIR DIRECTION: Press this button and release it quickly, the

'\\\/

Cooling model

j. ............................. -\

\,

Cooling/heating model

directional swing feature of the horizontal louver is activated. The louver swings for a certain angle

for each press. If keep pressing the button for more than 2

seconds, the Auto swing feature

will be activated. Press it again, the louver stops moving. When

the louver swing at a position which would affect the cooling and heating effect of the air conditioner, it would automatically change the swing direction (Not applicable to units without this function).

@LED DISPLAY: Press this button

to clear the digit display in the air conditioner, press it again to activate it.

B TEMP Button ; Push this button to increase the indoor temperature setting.

B FAN SPEED: Used to select the

Fan Speed in four steps - AUTO, LOW, MED or HIGH. Each time the

button is pressed, the fan speed mode is shifted.

ON/OFF: Push this button to start operation, push the button again to stop operation.

TIMER ON; Press this button to initiate the auto-on time sequence. Each press wilt increase the auto- timed setting in 30 minutes increments. When the setting time displays 10:00, each press will increase the auto-timed setting 60 minutes increments. To cancel the auto-timed program, simply adjust the auto-on time to 0:00.

TIMER OFF; Press this button to initiate the auto-off time sequence.

LOCK: When you press the recessed LOCK button, all current settings are locked in and the remote controller does not accept any operation except that of the LOCK. Press again to cancel the LOCK mode.