Craftsman 139.53625SR, 139.53699SR Taving a Problem? Review Pages 2 and 3 Before Proceeding

!taving a Problem? Review Pages 2 and 3 Before Proceeding

SITUATION

i,,N i,ii ii i i

OPENER DOESN'T OPERATE FROM EITHER THE WALL PUSH BUTTON OR TRANSMITTER

OPENER OPERATES FROM

TRANSMITTER BUT NOT FROM WALL PUSH BUTTON

DOOR OPERATES FROM

WALL PUSH BUTTON BUT NOT FROM THE TRANSMITTER

TRANSMITTER HAS

SHORT RANGE

THE GARAGE DOOR OPENS AND CLOSES BYITSELF

DOOR DOESN'T OPEN

COMPLETELY

DOOR DOESN'T CLOSE

COMPLETELY

DOOR WON'T CLOSE

PROBABLE CAUSE & SOLUTION

1 Have you disengaged all door tocks? Review Step 8, page 14r

2Does the opener have electric power? Plug a tamp into the outiet. If it doesn't light, check fuse box or circuit breaker (Some outlets are controlled by a wail switch.)

3Repeated operation may have tripped the overload protector in the motor, Wait 15 minutes Try again.

4.is there a build-up of ice or snow under door? Door may be frozen to ground, Re- move any obstruction

5.Remove beIl wire from opener terminals. Short red and white terminals by touch-

ing both terminals at same time with a piece of metal (screwdriver or coin) if opener runs, check for a faulty wire connection at wa)l push button or a short, under stapIes.

................i ,, HI

1Is wail push button _it? If not, refer to No 5 above and fo)low same procedure

2Are wiring connections correct? Review Step 6, page 13.

1Does the battery test light glow when transmitter push button is pressed? if not, replace the battery

2 If you have two transmitters and only one operates, review the code setting procedures on page 19 ALL transmitters must be set to same code.

3 )s transmitter(s) operating any other remote controf devices? See the code setting procedures on page 19.

4 Dfd you press the transmitter button designated to operate garage door opener?

5 Reprogram receiver and ALL transmitters. Try setting ALL transmitter code switches on plus, center or minus positions If transmitter(s) works, you can try a random code switch setting again, if you desire.

1 Check battery test light. If the light is dim, change the battery

2Change the location of the transmitter in the car.

3A metal garage door or foil-backed insulation or metal siding will reduce the

transmission range Antenna extender kit is available from any Sears Store or Service Cente[

4Check to be sure antenna on the back panel of opener extends fully downward_

1is there a neighbor with a garage door opener using the same frequency code? Change your code Review page 19

2.Check to be sure that none of the transmitter ptJsh buttons is stuck in the 'down' position

3.Remove betl wire from opener terminals and operate from transmitter only, If this solves the problem, the wall push button is faulty (replace), or there is a short or broken wire between push button and opener.

1.Is something obstructing the door?

2.If door opens at least 5 feet, travel limits may need to be increased. One turn equals 2 inches of travel, See page 17,

REPEAT SAFETY REVERSE TEST after the adjustment is complete.

3.If door has been working properly but now doesn'topen all the way, increase the UP FORCE. See page 17.

REPEAT SAFETY REVERSE TEST after the adjustment is complete°

"L IS something obstructing the door?

2.Review the Trave! Limits Adjustment Chart on page 17.

REPEAT SAFETY REVERSE TEST after any adjustment of door arm length, close force or down limit.

The Infrared Reversing Sensor (tf you have installed this accessory) may

misaligned or obstructed Disconnect sensor and check door operation. V problem disappears, correct alignment

2O