Craftsman 139.53675SRT Install the Lights and the Lenses, Install the lenses, Beginning on

Page 19

6_AttachtheUserSafetyInstructionlabeltothewall nearthedoorcontrol,andtheMaintenance Instructionlabelin aprominenttocai_onthe insideofthegaragedoor.

Page 32 explains how to use the door control.

Installation Step 7

Install the Lights and the Lenses

n

i

nl

i nil n I

i Ul u

i i I u

II

i

Install the lights:

•Install a 75 watt maximum light bulb in each socket. The lights will tum ON and remain lit for approximately 4-1/2 minutes when power is connected. Then the lights will turn OFF.

o If the bulbs bum out prematurely due to vibraUon, replace them with standard neck "Garage Door Opener = bulbs.

Install the lenses:

*Apply slight pressure on the sides of each lens and slide the tabs into the slots in the side panels.

. For convenience, the lenses may be installed after Adjustment Step 4 on page 30.

.. Reverse the procedure to remove _e lenses.

Do NOT connect the power and operate the

openerat this time. The trolley will travel to the

full open posltlon but will not return to the

close position until the sensor beam is connected and properly aligned.

See Safety Reversing Sensor instructions

beginning on page 21.

Lens

"Cab

T_b

Installation Step 8

Attach the Emergency

Release Rope and Handle

i

•Thread one end of the rope through the hole in the top of the red handle so "NOTICE" reads right side up as shown. Secure with an overhand knot.

The knot should be at least 1" from the end of the rope to prevent slipping.

•Thread the other end of the rope through the hole in the release arm of the outer trolley.

•Adjust rope length so the handle is 6 feet above the floor. Secure with an overhand knot.

If it is necessary to cut the rope, heat seal the cut end with a match or lighter to prevent unraveling.

Do not use the red handle to pull the door open or closed. The rope knot could become untied and you could fall, Use the emergency release only to disengage the trolley and, if possible, only when the door is closed.

Garage doors are heavy. If the door is open when the handle is pulled, the door could

close inadvertently if it ts not properly

balanced. Serious injury may result to persons under the door. Make sure the doorway is clear

of persons and obstructions before pulling handle when door is open.

- _t_======_

Overhand

_OF. ....... " _

Knot

T_oliey

Release Arm

Rope --

_--REmergency

Overhand

Kno_

eiease Handte

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Sears, Roebuck and Co, Hoffman Estates, IL 60179 U.SoA Owners ManualElectrical Start by Reviewing these Important Safety Alert SymbolsAssembly WarrantyYoull Need Tools Before you begin, survey your garage area to To your installationCenter of the door. See pages 12 Closed Position Carton Inventory Oll Installation HardwareRight Wrong Assembly Section Pages 8Hardware Shown Actual Size Remember to use only these screws! Any other Assembly StepInstall the Trolley on the T-rail Fasten the T-rail to the OpenerSpt Install the Chain/Cable Attach the Sprocket CoverGhten the Chain & Cable Important Installation InstructionsDetermine Header Bracket Location Installation Section Pages 12 Installation StepProceed to , page t4 Pivot hardware Proceed to ,Fasten the Header Bracket to the Wall Install the Header BracketFasten the Header Bracket to the Ceiling Installation Step Completed Position the OpenerHang the Opener Serious injury or death Install the Premium Control ConsoleAttach the Emergency Release Rope and Handle Install the Lights and the LensesInstall the lenses Do not connect the power and operateElectrical Requirements If permanent wiring is required by your localCode, refer to the following procedure WiringBe sure power to the opener is disconnected Safety Reversing SystemAtemate Roor Hardware ShownPage Fasten Door Bracket They apply to one-piece doors also Hole Alignment Alternative Connect Door Arm to TrolleyAssemble the Door Arm Adjustment Procedures for One-Piece DoorsDecrease UP limit If the door does not close completely Adjustment Section Pages 28 Adjustment StepAdjust the UP and Down Limits If door does not open at least 5 feetSystem. The door might not reverse properly Adjust ForceHow and When to Adjust the Forces Proper operation of the safety reverseTest Test The Safety Reversing SensorImportant safety check Repeat this test once a month and adjust as neededCare of Your Opener MaintenanceTo reduce the risk of severe Injury or death to personsTo Activate OperationGarage Door Opener Function Remote ControlFf you have a Premium Control Console Ff you do not have a Premium Control ConsoleDoor operates from the Door Control, but not from Probable Cause and SolutionSituation Control, but not fromSituation Probable Cause Solution Having a Problem?Installation Parts Rail Assembly PartsPner Assembly Parts 1918 Repair PartsFf you do not have a Premium ControlConsole If you have a Premium Control ConsoleIndex Call 24 hours a day, 7 days a week For the repair or replacement parts you need800-827=6655 Call 7 am 7 pm, 7 days a week

139.53675SRT specifications

The Craftsman 139.53675SRT is a versatile garage door opener designed to offer homeowners convenience, reliability, and a host of advanced features. Known for its ease of use and robust performance, this model has gained popularity in various residential settings.

One of the standout features of the Craftsman 139.53675SRT is its powerful 1/2 horsepower motor. This motor is designed to lift standard garage doors with efficiency and speed, providing a smooth opening and closing experience. Whether your door is lightweight or heavy, this opener can handle the task with minimal noise and vibration.

Incorporating advanced technology, the Craftsman 139.53675SRT features a rolling code security system. This enhances safety by changing the access code every time the remote is used, preventing unauthorized access. This technology ensures that you can trust your garage door opener to keep your home secure.

Another notable characteristic of this model is its compatibility with smartphone technology. The unit supports Smart Garage technology, allowing users to connect via their smartphones. Users can monitor and control their garage door from anywhere, adding an extra layer of convenience to everyday life.

Additionally, the Craftsman 139.53675SRT comes with a wireless keypad, which allows for keyless entry and makes it easy for family members or trusted friends to access the garage without needing to give out remotes. This keypad can be mounted outside the garage door, ensuring that anyone needing entry can do so without hassle.

Installation is made simpler with the detailed instructions provided, and the opener is designed to work with most standard garage door sizes. Additionally, the unit features a soft start and stop mechanism that reduces wear on the door and opener, extending the lifespan of both.

Safety is a priority with the Craftsman 139.53675SRT. The unit is equipped with safety sensors that detect obstructions in the door’s path, automatically reversing if anything is in the way. This feature helps to prevent accidents and injuries, particularly in households with children or pets.

In summary, the Craftsman 139.53675SRT is a reliable and feature-rich garage door opener that prioritizes convenience, safety, and technology. With its powerful motor, advanced security features, and smart connectivity, it has positioned itself as a strong contender in the market for garage door openers.
Top Page Image Contents