Frigidaire FRA122CV1 warranty Before You Call, Occurrencesolution

Page 8

Before You Call

Before calling for service, review this list. It may save you time and expense. This list includes common occurrences that are not the result of defective workmanship or materials in this appliance.

OCCURRENCESOLUTION

Air conditioner will not operate.

Wall plug disconnected. Push plug firmly into wall outlet.

Plug Current Device tripped. Press the RESET button.

House fuse blown or circuit breaker tripped. Replace fuse with time delay type or reset circuit breaker. Selector Control in OFF position. Turn selector to ON (some models) or the desired FAN or COOL setting.

Unit turned off by moving thermostat to a higher number and then immediately turning back to a colder number. Wait approximately 3 minutes. Listen for compressor to restart.

Unit turned off and then on too quickly. Turn unit off and wait 3 minutes before restarting.

Temperature selector set too low. Adjust temperature selector to higher number for cooling.

Air from unit does not feel cold enough.

Turn selector to a higher COOL position.

Temperature selector set too warm. Set temperature selector to colder temperature.

Room temperature below 60O F (16O C). Cooling may not occur until room temperature rises above 60 O F (16 O C).

Temperature sensing tube touching cold coil, located behind air filter. Straighten tube away from coil.

Air conditioner cooling, but

Outdoor temperature below 60 O F (16 O C). To defrost the coil, set selector to a FAN position. Then, set

room is too warm - ice forming

thermostat to warmer position.

on cooling coil behind decorative

 

Air filter may be dirty. Clean filter. Refer to Care and Cleaning section. To defrost, set selector to FAN.

front

 

Temperature selector set too cold for night-time cooling. To defrost the coil, set selector to a FAN

 

 

position. Then, set temperature selector to warmer position.

 

 

Air conditioner cooling, but room

Dirty air filter - air restricted. Clean air filter. Refer to Care and Cleaning section.

is too warm - NO ice forming on

 

Temperature selector set too warm. Turn temperature selector clockwise to a colder setting.

cooling coil behind decorative

 

Air directional louvers positioned improperly. Position louvers for better air distribution.

front.

 

 

 

Front of unit is blocked by drapes, blinds, furniture, etc. - restricts air distribution. Clear blockage in

 

front of unit.

 

 

 

Doors, windows, registers, etc. open - cool air escapes. Close doors, windows, registers, etc.

 

 

 

Unit recently turned on in hot room. Allow additional time to remove “stored heat” from walls, ceiling,

 

floor and furniture.

 

 

Air conditioner turns on and off rapidly.

Dirty air filter - air restricted. Clean air filter.

Outside temperature extremely hot. Set to High Cool to bring air through cooling coils more frequently.

Noise when unit is cooling.

 

Air movement sound. This is normal. If too loud, turn selector to lower FAN setting.

 

 

 

 

 

 

 

Sound of fan hitting water-moisture removal system. This is normal when humidity is high. Close doors,

 

windows and registers.

 

 

 

 

Window vibration - poor installation. Refer to installation instructions or check with installer.

 

 

 

 

 

Water dripping INSIDE when

Improper installation. Tilt air conditioner slightly to the outside to allow water drainage. Refer to

unit is cooling.

installation instructions or check with installer.

 

 

 

 

 

Water dripping OUTSIDE when

Unit removing large quantity of moisture from humid room. This is normal during excessively humid

unit is cooling.

days.

 

 

 

 

 

Room too cold.

Temperature selector set too high, set to a lower number on temperature dial.

If These Solutions Fail, Call 1-800-944-9044 For Frigidaire Service.

8

2009 Electrolux Home Products, Inc.

All rights reserved.

 

 

 

 

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Use&Care Important Safety Instructions Grounding type wall receptacleUnit must be upright for one hour prior to operating Product Registration, Packaging & Normal Sounds Product Registration Record Your Model and Serial NumbersTemperature Selector Operating InstructionsOperating Instructions Care and Cleaning & Energy Saving Ideas Care and CleaningOccurrencesolution Before You CallMajor Appliance Warranty Exclusions This warranty does not cover the following

FRA122CV1 specifications

The Frigidaire FRA122CV1 is a versatile and efficient window air conditioning unit designed to provide powerful cooling while maintaining user-friendly features. With a cooling capacity of 12,000 BTUs, this model is ideal for rooms up to 550 square feet, making it suitable for living rooms, bedrooms, and offices.

One of the standout features of the FRA122CV1 is its Energy Efficiency Ratio (EER) rating, which ensures that the unit operates efficiently, helping consumers save on energy bills. It is Energy Star certified, meaning it meets stringent energy efficiency guidelines set by the U.S. Environmental Protection Agency. This not only minimizes environmental impact but also provides peace of mind for users concerned about energy consumption.

The unit comes with three adjustable cooling speeds and three fan speeds, allowing users to customize their comfort levels based on individual preferences and environmental conditions. The built-in programmable timer adds convenience, enabling users to set the air conditioner to turn on or off at specified times—perfect for ensuring a comfortable environment upon returning home without wasting energy.

Another key feature of the Frigidaire FRA122CV1 is its remote control, which provides added convenience for adjusting settings from across the room. The unit also includes a digital display, making it easy to read and adjust settings with the push of a button.

The FRA122CV1 is equipped with a dehumidification feature that removes excess moisture from the air, enhancing comfort during humid months. This is particularly beneficial in regions with high humidity levels, as it helps to create a more enjoyable indoor environment.

Installation of the Frigidaire FRA122CV1 is straightforward, facilitated by the included mounting kit. The unit is designed to fit standard window sizes, and its side panels extend to ensure a proper fit, effectively sealing gaps to prevent air leaks.

Furthermore, cleaning and maintenance are made easy with a removable, washable filter. Regular maintenance of the filter increases air quality and ensures the air conditioner operates smoothly.

Overall, the Frigidaire FRA122CV1 window air conditioner combines efficiency, convenience, and powerful cooling capabilities, making it a robust option for anyone looking to enhance their indoor comfort during hot weather.
Top Page Image Contents