Air Conditioner Features
(continued)
TIMER: DELAY STOP/START FEATURE:
DO THIS:
PRESS TIMER
BUTTON
THEN DO THIS:
PRESS UP ( ▲ ) OR
DOWN ( ▲ ) BUTTON
CHECK FILTER FEATURE:
FAULT CODES
If the display reads “AS”, a sensor has failed. Contact your Authorized Frigidaire Service Center
YOU WILL SEE HOW MUCH TIME IS CHOSEN:
LIGHT On
Note: For Delay Stop, the unit must be in the On position.
Note: For Delay Start, the unit must be in the Off position.
To adjust timer setting, tap or hold the UP arrow(
) DOWN arrow(
) to change delay timer at .5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time remaining until start (8, 7.5, 7, etc.). The Delay Start mode automatically selects cooling with maximum Fan Speed. The temperature maintained will be the same as previously set. To change the set temperature, press “ COOL” then Up or Down arrows until the desired temperature is indicated on the display. After 5 seconds, the control will automatically change the display back to the hours remaining until the unit will start/stop. Turning the unit “ON” or “OFF” at any time will cancel the Delay Start/ Stop function.
The Delay Start/Stop Feature will work until the unit either starts or stops. Once that happens the above steps have to be repeated again.
YOU WILL SEE: | LIGHT On |
| |
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation and cooling. The LED (light) will illuminate after 250 hours of operation. To reset after cleaning the filter, press the “ Check Filter ” button and the light will go off.
If the display reads “ES”, a sensor has failed. Contact your Authorized Frigidaire Service Center
8