OPERATING PROCEDURE | PHOTOS |
1.Removing the filter
(1)Press the tabs of the filter and remove the filter in the direction of the arrow 1.
2.Removing the bottom plate
(1)Remove the fixing screws (two) of the bottom plate(N) and remove the plate.
3.Removing the cable |
|
|
(1)Remove the cable(P) threw the rubber bush. |
|
|
| (M) |
|
4.Sliding the fan section |
|
|
(1)Remove the fixing screws(two) of the fan base | 1 (N) |
|
plate. | Fig.1 | |
(2)Pull up the fan section(Q) in direction of the arrow |
|
|
2and slide the direction of the arrow 3.
5.Removing fan casing and sirroco fan | (Q) | |
(1)Remove the fixing screws (four) of the fan cas- |
| |
ing(R). | (P) | |
(2)Remove the fan motor shaft fixing screw and | ||
| ||
remove the fan casing(R) and sirroco fan. | 2 | |
6.Removing the fan motor |
| |
(1)Remove the condensor cable | 3 | |
(in case of | ||
(2)Remove the fixing screws of the motor fixtures |
| |
(two) and remove the motor. |
| |
Notice:Incase of the |
| |
stick out the motor shafts on both side of the motor. |
|
Fig.2
(R)
fan motor shaft fixing screw
Fig.3
21