Directed Electronics A600/4, A1200/4 manual Amplifier Status Leds

Page 7

AMPLIFIER STATUS LEDS

1 2

The LEDs provide the following indications:

1.Power - These LEDs illuminates the center Precision Power logo background when the amplifier power is turned on.

2.Short - These LEDs behind the PPI logo will flash to indicate a short on the output.

2.Thermal - These LEDs behind the PPI logo will extinguish if the amplifier is in thermal shutdown protection.

Note: Read the AP-IV Protection Circuit section for additional information regarding Short and Thermal protection.

6

Image 7

Contents Amplifier Models Table of Contents Congratulations ServiceCEA Specifications FeaturesWHAT’S Included General Specifications SpecificationsFuse Requirements Amplifier Status Leds TOOLS/PARTS for Installation Wiring Powerlocktm Ground Wiring Current Draw Charging SystemPower Wire Size Amplifier Bridging Power Lock ConnectorsMixed Mono Output A600/4 Front Plate Diagram Rear Speaker Connector Speaker PowerLockTM connectorPage A1200/4 Front Plate Diagram A600/4 END Plate DiagramPage A1200/4 END Plate Diagram Source Headunit InputsA600/4, A1200/4 Block Diagram Qbass Advanced Instrumentation InputQbass Plus QBASS/QBASS Plus SpecificationsOUT TC-X Crossover A600/4, A1200/4Crossover Detent Chart AP-IV Protection Circuit Adjusting Input GainInput Combine High Mass Internal HeatsinkOpposite Channel Same Channel Limited TWO Year Consumer Warranty