Electrolux EOS 6700 Cleaning and Maintenance, Cleaning materials, External cleaning, Oven Cavity

Cleaning and Maintenance

Before any cleaning switch the oven off and let it cool down. Never use steam or steam machines to clean the appliance.

Important! Before carrying out maintenance and cleaning operations, make sure that your oven is disconnected from the mains power supply.

The oven should be kept clean at all times. A build- up of fats or other foodstuffs could result in a fire, especially in the grill pan.

Cleaning materials

Before using any cleaning materials on your oven, check that they are suitable and that their use is recommended by the manufacturer.

Cleaners that contain bleach should NOT be used as they may dull the surface finishes. Harsh abrasives should also be avoided.

External cleaning

Regularly wipe over the control panel, oven door and door seal using a soft cloth well wrung out in warm water to which a little liquid detergent has been added.

To prevent damaging or weakening the door glass panels avoid the use of the following:

•Household detergent and bleaches

•Impregnated pads unsuitable for non-stick saucepans

•Brillo/Ajax pads or steel wool pads

•Chemical oven pads or aerosols

•Rust removers

•Bath/Sink stain removers

Clean the outer and inner door glass using warm soapy water. Should the inner door glass become heavily soiled it is recommended that a cleaning product such as Hob Brite is used. Do not use paint scrapers to remove soilage.

DO NOT clean the oven door while the glass panels are warm. If this precaution is not observed the glass panel may shatter.

If the door glass panel becomes chipped or has deep scratches, the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Contact your local Service Force Centre who will be pleased to advise further.

Oven Cavity

The enamelled base of the oven cavity is best cleaned whilst the oven is still warm.

Wipe the oven over with a soft cloth soaked in warm soapy water after each use. From time to time it will be necessary to do a more thorough cleaning, using a proprietary oven cleaner.

DO NOT attempt to clean catalytic liners.

Oven Shelves and Shelf Supports

To clean the oven shelves, soak in warm soapy water and remove stubborn marks with a well wetted soap impregnated pad. Rinse well and dry with a soft cloth. The shelf supports can be removed for easy cleaning.

Proceed as follows:

1)remove the front screw while keeping the shelf support in position with the other hand (see diagram 1);

2)disengage the rear hook and take off the shelf support (see diagram 2);

1)once the cleaning is carried out, refit the shelf supports following the procedure in reverse.

Please, ensure the retaining nuts are secure when refitting the shelf support.

When cleaning the shelf supports, take care not to remove the lubricating grease behind the telescopic runners. This is meant to ensure their

good operation.

1

2

15