Electrolux 726683, 726682, 736684 Report Printouts example of report printout, Reversing the door

C.2 HACCP CONNECTIONS (ACCESSORIES)

C.2.1 Basic system connection (accessory code F880048) The printer can provide a printout of data obtained by the sensor connected to the electronic board. For this,

connect the serial cable (screened) to the printer and the appliance itself.

Set the printout interval (see parameter TPRN); and define the type of report by means of the parameter “PRND”.

C.2.2 REPORT PRINTOUTS (fig.11 example of report printout)

Reports are printed automatically when the appliance is switched on.

The printout gives the data obtained by the electronic board and indicates:

-the start date and time, repeated every 20 lines of temperature;

-the compartment temperature at preset intervals (user parameter TPRN);

-a description of the type of alarm generated and the alarm start and end time;

-defrost start and end time.

C.3 MODULARITY OF MAIN

COMPONENTS

The Heavy Duty range refrigerated counters have been designed with a modular structure. In this way the main components of the appliance can be easily replaced.

C.3.1 COOLING UNIT COMPARTMENT MODULARITY

The cooling unit assembly is located in the middle of the appliance in order to guarantee optimum ventilation inside the refrigerated compartment. To access the cooling unit assembly, for routine or extraordinary maintenance operations, proceed as follows:

-remove the chromed cap in the middle of the panel;

-remove the panel middle fixing screw;

-remove the 3 control panel fixing screws, one central and two lateral (right and left);

-remove the control panel then disconnect the wires from the connectors;

-loosen the 4 fixing screws located on the right and left side of the counters, then remove the complete cooling unit assembly;

-in this way the unit is completely removed from the refrigerated counter and routine maintenance operations can be carried out quickly and easily.

C.3.2 REFRIGERATED COMPARTMENT MODULARITY

The refrigerated compartments can be easily customized, therefore the structure with doors (inside food rack) can be quickly replaced by that with drawers. The operations necessary for customizing are given below.

C.3.2.1 Reversing the door

Remove the bottom hinge fixing screws and then the door. Remove the plate on the bottom part of the door and refit it on the opposite side. Shift the top hinge to the other side, place the door on the hinge then fix the bottom hinge in the special seats arranged on the other side.

C.3.2.2 Replacing fully insulated door compartment with drawer unit

To replace the fully insulated door compartment (inside food racks) with the compartment with drawer unit, carefully carry out the following:

-remove the door (see point C.3.2.1);

-remove the food racks from the metal support structure;

-remove the metal support structure, lifting it a little in order to take it out of the seat located on the bottom of the counter;

-insert the new drawer unit support structure, then secure it to the appliance compartment and fix with 4 screws.

-there are 3 types of drawer units: 1/3 drawers; 1/2 drawers; bottle holder.

The drawer units are available for “refrigerator” counter models but not for “freezer” models.

For installation of the drawer kit, refer to the instructions given inside the kit.

IMPORTANT:

The drawers must only be used with GN 1/1 pans of height 2.56"/65 mm, already included in the kit.

Note: As the fully insulated door compartments are modular and easily removed, it is possible to optimize all compartment cleaning operations. In fact the rack support structure can be quickly removed, giving complete access to the compartment for cleaning.

2 6