|
| Installation | 7 |
Freezer Drawer Alignment (if necessary) | To level the cabinet using the front rollers: |
| |
1 Slightly open freezer drawer. Lift the toe grille and |
| ||
1 | Check gasket seal around top, bottom, and sides |
| |
gently pull forward (see illustration). |
| ||
| of freezer drawer. |
| |
| 2 You can raise or lower each door. Use a 3/8 inch |
| |
2 | If gasket is not sealed, open drawer and slightly |
| |
socket wrench to turn the adjustment screws (1 |
| ||
| loosen four (4) drawer screws (two (2) on each |
| |
| per side). |
| |
| side) to allow drawer to rotate. |
| |
|
|
| |
3 Close drawer and recheck the seal on the gasket |
|
| |
| (A). Open the drawer grabbing by the sides in the |
|
|
| center (B). Be careful not to rotate the drawer. |
|
|
|
|
| To raise: turn adjustment screw clockwise. | |
|
|
| To lower: turn adjustment screw counterclockwise. | |
|
| 3 | Ensure both doors are | |
|
|
| touching the cabinet on all four sides and that | |
4 | Tighten four (4) drawer screws. |
| cabinet is stable. | |
4 | After unit is leveled, lower | |||
5 | Recheck gasket seal. | |||
| contacts the floor. | |||
|
|
|
Push Against Freezer Drawer
A
B
Grab Drawer
At Center
From Both Sides
Then
Pull Drawer Out
Door | Door |
| Raise |
Cabinet Leveling & Refrigerator Door Alignment (if necessary)
Guidelines for final positioning of your refrigerator:
•All four corners of the cabinet must rest firmly on the floor.
•The sides should tilt 1/4 inch (6 mm) from front to back (to ensure that doors close and seal properly).
•Doors should align with each other and be level.
Most of these conditions can be met by raising or lowering the adjustable front rollers.
Leg |
Lower |
5Install the toe grille by fitting into place.