Maintenance and Cleaning
Symptom | Solution | |
| Adjust the thermostat to give correct | |
| temperature control. | |
| Check that the door is closed. | |
The compressor runs continuously | Large quantities of food have recently | |
| been placed in the cabinet and/or door is | |
| frequently opened. | |
|
| |
| Check that air ventilation is not | |
| obstructed. | |
| If the door seal is not airtight (probably | |
| after reversing the door) apply warm air | |
| to the non sealing area using a hair dryer | |
Excessive build up of frost. | set to a gentle heat. (do not use a fan | |
| heater for this purpose). This will make | |
| the rubber more supple and allow it to | |
| revert to its original shape. | |
|
| |
Noise | Refer to Normal Operating Sounds | |
The compressor does not start | This is normal, the compressor starts after | |
immediately after changing the | ||
a period of time. | ||
temperature setting. | ||
| ||
|
|
If after the above checks there is still a fault, call your local AEG Service Force Centre.
Please note that proof of purchase is required for
Regulations, Standards, Guidelines
This appliance was designed for household use and was manufactured in accordance with the appropriate standards. The necessary measures in accordance with appliance safety legislation regulations (GSG), accident prevention regulations for refrigeration appliances (VBG 20) and the regulations of the German Society of Electrical Engineers (VDE) were observed in the manufacture of this appliance.
The refrigerant circuit has been checked for leaks.
38 | 818 20 |