Electrolux 241721800 manual Changing the Filter, To change filter

Page 17

Automatic Ice and Water Dispenser

PureSource2TM Ice and Water Front Filter (some models)

NOTE: If you purchased a refrigerator with a PureSource2TM Ice andWater front filter, please read the following use and care information. This ice and water filter system filters water to your ice maker and water dispenser. It is located in the upper right front corner of the fresh food compartment.

System Startup:

Water supply does not need to be turned off, however, do not use ice and water dispenser while installing filter.

The filter cartridge has already been installed in the filter housing at the factory. Refer to the How The Water Dispenser Works section to properly fill the system with water.

Changing the Filter:

Water conditions vary throughout the world, but changing the water filter every 6 - 9 months normally will ensure the highest possible water quality. The Filter Status light will turn red after approximately 400 gallons of water has flowed through the ice and water dispenser. Also, if the filter has been in a refrigerator that has not been in use for awhile (during moving for example), change the filter before reinstalling the refrigerator. The dispenser system will also operate without filtration (with filter cartridge removed and bypass installed).

To change filter:

It is not necessary to turn the water supply off to change the filter.

1.Turn the ice maker’s power switch to the Off (“O”) position (See illustration on page 14).

Order new filter cartridges through the dealer where you bought the refrigerator or contact the Electrolux Customer Care Center . It might be good to order some filter cartridges when you first install your refrigerator. Be sure to ask for the FC-100 PureSource2™ replacement cartridge.

The PureSource2TM Ice and

Water Filter System NGFC 2000 with the PureSource2TM cartridge FC 100 is tested and certified by NSF International,

the nationally recognized and respected, not for profit, certification organization for public health safety. The PureSource2TM Filter system is tested and certified to ANSI/ NSF Standards 42 and 53. See performance data sheet for specifications. This system should not be used on water that is microbiologically unsafe or with water of unknown quality unless the water has been adequately disinfected before or after traveling through the filtration system.

•Rated Capacity - 1514 liters

•Rated service flow - 1.9 liters per minute

•Maximum Rated Pressure - 6.9 bars

•Maximum Operating Temp. - 37.8° C

2.Push the Filter Release Button, located to the right of the filter cartridge, to release the filter from the housing. To minimize the possibility of the filter falling out of the housing during removal, it would be best to hold the filter as it moves out toward you.

NOTE: A small amount of water may be released during this operation. You should have a paper towel or dish cloth handy to wipe up any water that may drip out of the filter or housing.Two small holes near the back of the housing have been added for any excess water to escape. It would be best to clear away any food near this area on the top shelf in advance of removing the filter.

3.Pull the old filter cartridge straight out of the housing.

4.Discard the old filter.

5.Remove the new filter cartridge from the packaging and insert into the filter housing the same way the old one came out.

6.When the cartridge is almost in, you will feel it stop against the clip assembly in the back of the housing. The clip assembly holds the filter cartridge firmly in place. At this point, you will need to push firmly until the cartridge snaps fully in place.When completely in place, the front of the filter cartridge will be flush with the front of the housing.

7.Turn the ice maker’s power switch to the On (“I”) position.

8.Fill a glass with water. As you are doing this, check for leaks at the filter housing. There will be noticeable spurts and sputters as the system pushes the air out through the system and out the dispenser nozzle.This is normal.

9.After you have run one glass of water, continue to flush the system for approximately 3 minutes to assure that the purest water possible is stored in the water storage tank.

IMPORTANT: Resetting The Filter Status Light (some models)

After replacing the filter cartridge, it will be necessary to press the Filter Reset button located on the ice and water dispenser. This will reset the Filter Status light. Push the reset button until the green, red and amber lights flash (10-15 seconds). Please refer to the complete dispenser operating instructions attached to the inside of the freezer door.

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Use & Care Guide Make a Record for Quick Reference Welcome & CongratulationsPlease Read ANS Save this Guide For Your Safety Important Safety InstructionsChild Safety Proper Disposal of Your Refrigerator or FreezerInstallation To Connect Water Supply Line To Ice Maker Inlet Valve Before Installing The Water Supply Line,You Will NeedDoor Removal Instructions Door Removal InstructionsTo Remove Refrigerator Door To Remove Freezer DoorFeatures At a Glance If the Temperature Displays Flash Temperature ControlsCool Down Period Refrigerator & Freezer ControlsTurning the Cooling System on and OFF Other Control FeaturesTo adjust cantilever shelves Cantilever Shelf AdjustmentLooking Inside ICE Cream Shelf Some ModelsSpecial Item Rack Some Models Adjustable Door BinsDoor Storage Tall Bottle Retainer Some Models Meat Keeper Humidity Control Some ModelsAutomatic ICE & Water Dispenser Operating Instructions Automatic Ice and Water DispenserHow the Water Dispenser Works ICE and Water Dispenser FeaturesHow the Ice Dispenser Works ICE Dispenser TipsRemove and empty the ice storage bin if Cleaning the ICE DispenserPureSource TM Ice and Water Filter some models To change filter Changing the FilterEnergy Saving Ideas Food Storage & Energy Saving IdeasFood Storage Ideas Normal Operating Sounds & Sights Care & Cleaning Chart Care & CleaningReplacing Light Bulbs Vacation and Moving TipsBefore You Call Problem Cause CorrectionTemperatures are TOO Warm ICE Dispenser Water Dispenser Problem Cause Correction

241721800 specifications

The Electrolux 241721800 is a high-performance refrigerator that stands out in the market due to its innovative features, energy efficiency, and sleek design. This model has garnered attention for its advanced technologies, which not only enhance food preservation but also ensure optimal user convenience.

One of the defining features of the Electrolux 241721800 is its advanced cooling system. This refrigerator employs an efficient dual cooling technology that separates the airflow between the refrigerator and freezer compartments. This not only prevents the mixing of odors but also maintains the ideal humidity levels in both areas, ensuring that fruits and vegetables remain fresh for longer.

Another notable characteristic of the Electrolux 241721800 is its Energy Star certification. This appliance is designed to be energy-efficient, consuming significantly less electricity compared to traditional refrigerators. By adhering to strict energy guidelines, it helps users save on utility bills while reducing their carbon footprint.

The interior of the refrigerator is designed with user convenience in mind. It features adjustable glass shelves that allow for customizable storage options, accommodating items of various sizes. The LED lighting provides bright and clear illumination, making it easy to find your groceries even in the darkest corners.

In addition to storage versatility, the Electrolux 241721800 includes a water and ice dispenser conveniently located on the front door. This feature not only eliminates the need to open the refrigerator frequently but also offers instant access to cold water and ice, enhancing the overall user experience.

For added convenience, the appliance is equipped with a digital temperature control system. This allows users to monitor and adjust the temperature settings with ease, ensuring food safety and optimal preservation. The external digital display provides a straightforward interface, making it easy to operate even for those who may not be technologically savvy.

Overall, the Electrolux 241721800 stands out as a reliable and feature-rich refrigerator that combines advanced technology with practical design. Its cooling performance, energy efficiency, and user-friendly features position it as an excellent choice for modern kitchens, catering to a variety of family needs while maintaining the freshness of your food.
Top Page Image Contents