Door Reversal

Disconnect from the electricity supply.

Remove all loose item, including food, store food in a cool place;

Gently lay the fridge/freezer on its back with the top held away from the floor by 5-8 cm (2-3 inches) of packing;

Remove the feet (2-3). Unscrew the bottom hinge (1).

Slide out the lower door from middle hinge (H) and remove the latter.

Slide out the upper door from pin (G), unscrew the latter and then screw it down into the hinge provided on the opposite side, after having removed the small plugs which should then be fitted on the opposite side.

Refit the upper door and the middle hinge on the opposite side.

Screw down the bottom hinge (1) on the opposite side by using the screws previously removed. Refit the feet (2-3) on the opposite side.

Unscrew the handle. Refit it on the opposite side after having pierced the plugs with a punch. Cover the holes left open with the plugs contained in the documentation pack.

The doors can be aligned by adjusting the middle hinge.

The middle hinge can be adjusted horizontally, with the help of a tool, after having slackened the two screws.

Attention

After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating the part involved with a normal hairdryer on a low setting.