Building-in
Before carrying out any work, remove the plug from the power socket.
Grid preparation
Left door opening:
Remove the left side (A) of the grid cutting it from the rear (see figure).
A
B
DO002/2
Right door opening:
Remove the right side (B) of the grid cutting it from the rear (see figure).
To position the grid on the appliance proceed as follows:
Apply the grid to the base of the appliance by pushing on to the clasps (a) until they click.
a |
a |
DO001 |
Building in the appliance under a worktop
The dimensions of the recessed installation area must correspond with those indicated in the figure.
600 |
550 |
min. |
600 |
DO013 |
Installation kit
1xB |
| 2xC |
1xA |
|
|
|
| 12 |
2 | 1 |
|
2 | 1 | 2 |
1 |
| |
|
|
1.Two cabinet securing brackets are supplied with the installation pack. They need to be assembled onto the cabinet prior to cabinet being pushed into the Kitchen aperture.
-To fit these brackets remove the two screws at the top left and right hand front corners of the cabinet.
-Position the two brackets as shown in the figure and replace the two securing screws.
Left hand | Right hand |
bracket | bracket |
15