2.Press function buttons 1 and 2 simultaneously and keep them pressed. The LED indicators for function buttons 1 to 3 will flash.
3.Press function button 1.
The LED indicator for function button 1 will flash. The
4.Pressing function button 1 increases the hardness setting by 1. (Exception: hardness setting 1 follows hardness setting 10).
5.When the hardness setting is correct, press the ON/OFF button. The hardness setting is now saved.
If the water softener is set electronically to “1”, this switches off the control indicator for special salt.
Water hardness |
| Setting for | Indicator | Number | ||||
| water hardness | |||||||
|
|
|
| of |
| |||
|
|
|
|
|
| on the multi- |
| |
in | in |
|
|
|
| acoustic | ||
| Range | Manual | Electronic | display | signals | 1) | ||
°d 2) | mmol/l 3) |
|
|
| ||||
51 - 70 | 9.0 - 12.5 |
|
|
| 10 4) | 10L | 10 |
|
43 - 50 | 7.6 - 8.9 |
|
|
| 9 | 9L | 9 |
|
37 - 42 | 6.5 - 7.5 |
| IV | 1 | 8 | 8L | 8 |
|
29 - 36 | 5.1 - 6.4 |
|
|
| 7 | 7L | 7 |
|
23 - 28 | 4.0 - 5.0 |
|
|
| 6 | 6L | 6 |
|
19 - 22 | 3.3 - 3.9 |
| III |
| 5 | 5L | 5 |
|
15 - 18 | 2.6 - 3.2 |
|
| 4* | 4L | 4 |
| |
|
|
|
| |||||
11 - 14 | 1.9 - 2.5 |
| II | 0* | 3 | 3L | 3 |
|
4 - 10 | 0.7 - 1.8 |
| I/II | 2 | 2L | 2 |
| |
|
|
| ||||||
|
|
|
|
|
|
|
|
|
below 4 | below 0.7 | I |
| 1 |
| 1 |
| |
| no salt | 1L |
| |||||
|
|
|
|
| required |
|
|
|
|
|
|
|
|
|
|
|
|
1)The water hardness will only be indicated acoustically if the acoustic signal has been activated.
2)(°d) German degree, measure of the hardness of water
3)[mmol/l] millimol per litre, international unit for water hardness
4)On this setting the length of the dishwashing cycle may be slightly longer.
*) factory setting
9