WARNING!
The electrical cable for the safety valve is in the
Take care when installing the water inlet hose
. Place the water inlet hose in such a way that it is always lower than the bottom edge of the safety valve.
If the water inlet hose or the safety valve is damaged, remove the mains plug immediately.
CAUTION!
A water inlet hose with safety valve MUST only be replaced by your local Service Force Centre.
Drain hose
Connect drain hose to the | The waste connection | Ensure that the hoses are | When connecting the |
sink. | must be at a maximum 60 | not kinked, crushed or en- | drain hose to an under |
| cm from the bottom of the | tangled. The internal di- | sink trap spigot, the entire |
| dishwasher. | ameter of the couplings | plastic membrane (A) |
|
| used for connections to | must be removed. Fail- |
|
| the waste outlet must be | ure to remove all the mem- |
|
| no smaller than the diam- | brane will result in food |
|
| eter of the hose provided. | particles building up over |
|
|
| time eventually blocking |
|
|
| the dishwasher drain hose |
|
|
| spigot. |
Electrical connection
CAUTION!
Safety standards require the appliance to be earthed.
Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the supply where the appliance is to be installed.
22