Electrolux ESF 64010 Something not working, Fault code, Malfunction, Possible cause, Solution

Page 28

28 electrolux something not working

Something not working

The dishwasher will not start or stops during operation.

Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the indications described in the chart, without calling out an engineer.

Switch off the dishwasher, open the door and carry out the following suggested corrective actions.

Fault code

●continuous flashing of the light of the running programme

●1 flash of the end of programme indicator light

●continuous flashing of the light of the running programme

●2 flashes of the end of programme indicator light

●continuous flashing of the light of the running programme

●3 flashes of the end of programme indicator light

Malfunction

The dishwasher does not fill with water

The dishwasher will not drain

Anti-flood device is activated

Possible cause

●The water tap is blocked or furred with limescale

●The water tap is turned off

●The filter (where present) in the threaded hose fitting at the water inlet valve is blocked

●The water inlet hose has not been correctly laid or it is bent or squashed

●The sink spigot is blocked

●The water drain hose has not been correctly laid or it is bent or squashed

Solution

●Clean the water tap

●Turn the water tap on

●Clean the filter in the threaded hose

●Check the water drain hose connection

●Clean out the sink spigot

●Check the water drain hose connection

●Close the water tap and contact your local Service Force Centre

Image 28

Contents Dishwasher ESF We were thinking of you Welcome to the world of Electrolux Contents Safety information General safetyChild safety Correct useInstallation Product description Control panel Indicator lights Wash Dry End of programme Salt Rinse aidSetting mode To cancel a set programme or a programme in progressFirst use Water hardness Adjusting the water Hardness setting Mmol/lUse Salt Setting electronically Dishwasher is factory set at level Setting manually Dishwasher is factory set at positionExamples Filling with dishwasher salt To fillFilling with rinse aid Daily use Loading cutlery and dishesElectrolux daily use Lower basket Electrolux daily use Upper basket Adjusting the height of the upper basket Maximum height of the dishes Upper BasketLower Basket To move to the higher position proceed as followsFill with detergent Use of detergentDetergent tablets Use of combi detergent tablets Setting and starting the programme with delay start Cancelling the delay startCancel a washing programme in progress End of programme indicator light will illuminateEnd of the washing programme Unloading the dishwasher Programme Washing programmes Type of load Programme description Soil Care and cleaning Cleaning the filtersExternal cleaning Frost precautionsNever try to remove the upper spray arm Prolonged periods of non- operationFault code SolutionSomething not working MalfunctionFault code Malfunction Dishes are not clean Dishes are wet and dull Wash results are not satisfactoryTechnical data Consumption values Programme Programme Duration MinutesEnergy Consumption KWh Water Consumption LitresFull load 12 standard place settings Hints for test institutesInstallation Fitting under a counter kitchen worktop or sinkProceed as follows LevellingWater supply connections Locknut must be correctly fitted to avoid water leaksWater outlet hose connection Installation electrolux Packaging material Environment concernsOld appliance Guarantee/Customer Service BelgiumAddress for our consumer services department Belgium Electrolux ServiceEuropean guarantee LuxembourgAlbania Belgique/België/Belgien Page 156998 62/0-00-21082006