14electrolux
C
Use detergent, but do not put dishes in the appliance.
WHEN THE APPLIANCE IS NOT TO BE USED FOR A LONG PERIOD
1.Disconnect the mains plug from the mains socket.
2.Close the water tap.
3.Leave the door open to prevent un- pleasant smells.
4.Keep the inner side of the appliance clean.
8.Put filter (A) into position in filter (B) and turn it clockwise until it locks.
CLEANING THE SPRAY ARMS
Do not remove the spray arms.
If the holes in the spray arms become clog- ged, remove remaining parts of soil with a thin pointed object.
EXTERNAL CLEANING
Clean the external surfaces of the appliance and control panel with a damp soft cloth. Only use neutral detergents. Do not use abrasive products, scouring pads or sol- vents (e.g. acetone).
INTERNAL CLEANING
We recommend, every 3 months to run a washing program for heavily soiled dishes.
FROST PRECAUTIONS
Caution! Do not install the appliance where the temperature is below 0 °C. The manufacturer is not responsible for damage caused by frost.
MOVING THE APPLIANCE
1.Disconnect the mains plug from the mains socket.
2.Close the water tap.
3.Remove the appliance and the hoses.
4.Do not tilt the appliance during trans- port.
WHAT TO DO IF…
The appliance does not start or stops dur- ing operation.
If there is a fault, first try to find a solution to the problem yourself. Refer to following charts. If you cannot find a solution to the problem, contact your dealer or the Cus- tomer Care Centre.
With some malfunctions, the display shows an alarm code:
• - The appliance does not fill with wa- ter
• - The appliance does not drain the water
• - The
Warning! Switch the appliance off before you do the suggested corrective actions.
Malfunction
The appliance does not fill with water
Possible cause
The water tap is closed.
The filter in the water inlet hose is blocked.
The installation of the water inlet hose is not correct. The hose is bent or squashed.
Possible solution
Open the water tap.
Clean the filter.
Make sure that the installation is cor- rect.