Electrolux 60870 user manual Safety information for the installation

Page 39

Installation and connection instructions 39

Installation and connection instructions

1Safety information for the installation

•Only transport the dishwasher in an upright position, otherwise salt water may run out.

•Before using the dishwasher for the first time, check for any damage caused in transport. Do not under any circumstances connect an appliance that is dam aged. In the case of damage, please contact your supplier.

•Never use the dishwasher if the mains cable, water inlet or drain hose are damaged; or if the control panel, work top or plinth area are damaged such that the inside of the appliance is freely accessible.

•Always plug the mains plug into a correctly installed shockproof socket.

•Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the supply where the ap pliance is to be installed. The fuse rating is also to be found on the rating plate.

•Multiy plugs / connectors and extension cables must not be used. This could constitute a fire hazard through overheating.

•The dishwasher’s cable must only be replaced by the Customer Care Depart ment or a registered electrician.

•A water inlet hose with safety valve must only be replaced by the Customer Care Department.

Image 39

Contents Favorit Page Contents General safety SafetyPrior to using for the first time Child safetyRating plate Filters Interior lighting Diagram of applianceCeiling spray arm Water hardness dial Dispenser For special saltControl panel ON/OFF buttonFunction buttons ON/OFF button is used to turn the dishwasher on and off Refill with rinse aid Control panel MultisplayCan indicate Refill with special saltPrior to using for the first time Setting the water softenerWater softener must be set manually and electronically Below Press function buttonAdding special salt Open the door Filling up with rinse aidSetting the amount of rinse aid required Rinse aid inflow activated when 3in1 on Activating rinse aid inflow when 3in1 function is selectedLoading cutlery and dishes Daily usePlace the grid insert on the cutlery basket Loading cutleryPlace knives, small spoons and small forks Cutlery tray in the cutlery basketPots, Pans, Large Plates Loading / Unloading lower basket and upper basketBeer glasses and champagne glasses Daily use Cups, Glasses, Coffee Service Spikes folded away More room for serv ing dishes Folded awayWith upper basket lowered 24 cm 29 cm Adjusting the height of the upper basketAdding detergent 20/30 ml of detergentClose the lid and press until it locks into place Detergent tablets Concentrated detergentsUsing 3in1 detergents Selecting the dishwashing cycle Cycle Table Selecting a programme Interrupting or aborting a dishwashing cycle Starting a dishwashing cycleNew dishwashing cycle Setting the Delay TimerRemoving the dishes Switching off the dishwasherCare and cleaning Cleaning the filters Remedying small malfunctions What to do if…Sink outlet is blocked Clean out sink outlet Control indicatorClean filters see chapter Cleaning the filtersWhistling noise can be Faulty PartmentDishwashing compart Ment is made from rustree Washer use If the dishwashing results are not satisfactory Dishes are still dirty Wrong dishwashing cycle was selected Drain hose is incorrectly positioned Old appliance Technical dataDisposal Packaging materialExample loading arrangements Upper basketLower basket with cutlery basket Cutlery basket Installation and connection instructions Safety information for the installationFree Installing the dishwasherPermitted water pressure Connecting the dishwasherConnecting to the water supply Connecting the inlet hoseSink outlet connection Water drainageAnti Extension hosesElectrical connection Guarantee/Customer Service European GuaranteeLU4 9QQ +352 42 431Sverige Service Service117 987 59/0-00-160407-01 Subject to change without notice